Hi.
I am using the NRF52 Development board, on Keil uVision, to implement a C program that uses Dynamic Structs. The Structs re-size themselves ( by increasing their capacity...
Hello,
I have an NRF51822 (redbealab ble nano) that I would like to use to count pulses in very low power mode.
Pulses are asynchronous
The rate of pulses can...
Hi
I'm attempting to read a PT-100 sensor value that is part of a voltage divider using a nRF52.
Both the reference resistor and the PT-100 is sampled while the voltage...
Hi
I have been searching the forums, but were not able to find an answer to my question.
I'm trying to sample 4 analog inputs on the nRF51-DK using the ADC hal. (SDK10...
Hi
I have been trying to get two NRF24L01 chips communicate with each other since a week now, without much success. All what I can find on the net is Arduino examples using...
Hi
I have done several projects with the nRF905. I know the device quite well. Normally I use the CD, AM and DR interrupt pins to determine the status of the device, my current...
i made this project to try to create RSC service on arduino
developer.bluetooth.org/.../runningspeedandcadence.zip
unfortunately the server starts but i'm not able to...
Hi,
i have a bunch of nrf51822 hwid 0024 or 001E.
With softdevice s110 version 7 everything worked fine, but starting with 8, they pretend to work fine (no error codes...
Using the pure-gcc makefiles, at present I only see this for a stack trace in the command line gdb client:
(gdb) bt
#0 0xfffffffe in ?? ()
#1 <signal handler called>...
If you have the most trivial main.c possible, with a main() which does nothing at all, compile, link and load it at 0x00000000, it runs fine and does nothing .. that's basically...
I have a nRF51822 program in which a button triggered event doesn't work as expected and crashes the program. The program may have potential race condition problem. Here is...
Hello,
I've overcome most of my problems using this wonderful Q&A system from other people. Recently I've moved from a nRF8001 + MCU to a nRF51
Using SDK 8.1.1, keil...
Hi all-
I apologize in advance for the noob question but I have spent loads of time on this and can't make progress. I am trying to work my way through the nrf51822 User...
I want to experiment with recording observations of the beacons with raspberry pi's.
Is there any precompiled firmware I can install on the nRF51822 smart beacon...
Is it possible to add a payload (1-2 bytes) to the beacon advertising packet?
I intend place an ADC output to the payload. For now, I'm using nRF51-DK but later wants to...
Hello,
I'm developping an application using softdevice S130 with the nRF51822 evaluation kit.
The device has to scan multiple devices, and to save power, I'm storing the...
The SDK defines functions for operating on "ports", which are the output space divided into 8-bit chunks:
nrf_gpio_port_clear
nrf_gpio_port_dir_set
nrf_gpio_port_read...
As previously seen on softdevices topics ( devzone.nordicsemi.com/.../) I need to restrict BLE advertisement on only one channel for sniffing purpose.
The thing is, I cannot...
Bluetooth Smart Internet gateways (GATT)---Available early 2015 through the HTTP Proxy Service (HPS) & RESTful API white papers....
what does it mean..? is it available...
Hello,
I started to make an app for a board with nRF51822 with softdevice S120 version 1.0.1. Now I would like to have the DFU implementation in it but I am stuck at the...
