Hi,
We're looking for a low-latency 2.4GHz solution (not BLE) and the nRF51822 is oft-quoted as providing low latency, but what are the typical ms figures we could achieve...
Hello all,
in my previous question (Switch between applications (multiple services.h)) I got the advice to merge my two services into one service, including a HID over...
I am trying to create an nRF8001 based application that will broadcast battery levels (pipes broadcast, set), and give out temperature data (pipe indicate - TX_ACK) to connected...
Hi,
I'm using redbearlab's nrf51822 board. It is a arduino compatible board and hence it is using 0,1 (mapped to 9 and 11 for nrf51822). How do I make printf print to this...
An external PA/LNA is used to extend range of nRF51822, and S110 is used for BLE, How to switch between PA and LNA? and how to disable PA/LNA when there isn't transceiving...
Hi...
Can anybody help me to run ble_peripheral example (ble_app_hrs for S130). I have build and load the code successfully but cant see the advertisement. But while debugging...
I am working with the nRF8001, and I'd like to create a services.h file that will let me broadcast battery level and as well as allow temperature to be read by a peer.
...
Hi,
I'm porting an older application from Keil to SES. I'm using soft device S110 7.1 and the nRF51822ac.
Help in setting up SES FLASH and RAM would be most appreciated...
I have been working on a project (for profit) that uses a BLE Nano device along with Nordic SDK. To start the project I downloaded a copy of the Nordic SDK 8.1 examples and...
Hello,
I just downloaded Keil and ran through a few tutorials for the nRF51 Dev Kit, so I am brand new to this development environment.
I am trying to get the nRF51422...
Hello Nordicsemi,
i need to develop a system in which i have identify a user presence in a particular area
for that i m planing to design a BLE enable device for a user...
Hi,
I followed the steps to setup my nRF52 DK with eclipse. I could also build the code without errors. However, when I try to debug it, it says cannot connect to J-Link...
I am working on a project using a ble nano (nrf51822) using the Nordic SDK 8.1. In the examples I found a way to control an LED using the methods LEDS_ON and LEDS_OFF. I wanted...
Hi all, I am trying to use the UART hardware module inside the nRF52 DK. I am very new programming with Nordic chips and C, my previous experience is programming Arduino and...
I don't have a QFN package, I have a WL-CSP package. Presumably, this define should be changed to NRF51822_??AA_??, but I can't find anyplace where the options are listed...
Please can any one tell me that how to recognize the sdk version of that we are used it can be predict from softdevice version?
for ex. •S132 SoftDevice v2.0.0 is used in...
Hi,
I am working on a project that includes eddystone format. I am using SDK v13 sample example. When ı try to disable auto relock feature, ı cannot read or write any adv...
Is there any way to print all SDK documents at once?
I'd like to print all of the SDK v12.0 Documents and carry it with in offline,
But I can hardly find any PDF Document...
Hi.
I'm trying to figure out how to properly use GPIO pins, but so far I did not find a document explaining how to use GPIO with nrf included functions.
I found bits and...
