I'm trying to implement channel scanning in our nrf24lu1p based USB dongle.
I'm following the specs and basically loop though each channel ;
loop
stop listening
set...
Hi,
I am using the NRF8001 in UART mode and attempting to bond with my android device (Lollipop 5.0 Nexus 6).
i am using the nordic arduino sdk which is found here:...
Hi, I'm using the nRF8001 in an application that requires security so bonds to the remote client/central. My device supports firmware upgrades that may involve new nRF8001...
Hello.
Initially when reading the Gazell documentation I didn't think it'd be a problem but now in Keil seeing this has introduced some doubt whether it's a thing:
...
We would like to be able to calibrate the rRF9E5 ADC
Our proposal is to permanently fit voltage dividers, each using two precision resistors, on two of the ADC Ports and...
At some point in the past I had nrf51+gdb+breakpoints working just fine. I even have a bunch of __BKPT() calls in my various error handlers to trap into the debugger.
At...
Dear All,
I would like to know information about QDID for nRF5 SDK for Mesh v4.2.0, we are developing costumed equipment using NRF52833 and we need to start the process...
Dear Nordic support team.
Our product nearly complete Rnd stage.
We face only one thing relate to "Cannot reconnect after unpair device with smart phone".
debug wit...
How can i give command from android device to ble board to get the percentage, temperature, or reset or shutdown the device with the help of receiving command from android...
I'm trying to register the SIM card of the 9160 DK at nRF Connect website,
but the website is always showing "still working..." for more than 15 minutes.
Do you have a...
Hello,
I am experimenting with setting up a network via grouping in the following manner.
Bulb_1 will be put into identification mode, and Switch_1 will detect Bulb_1...
Hello,
I am trying to send gps data using MQTT protocol. For this purpose I wanted to combine MQTT simple example with the GPS example. I added all the methods/dependencies...
Hello,
I started to work witn NRF Connect SDK with nrf52840-dk? I mapped lots of peripherals to NRF Connect SDK. There are no problems. However, I try to map nrf_fstorage...
Hello
I am testing out a blinky FreeRTOS example that's a part of the SDK and would like to use SystemView to visualize context switching and tasks. Are there any steps...
Hello,
We're using a BLE connection configured with a 15ms connection interval, and a radio event notification configured to fire 800us prior to a radio event. I'd like...
Hi,
I trying to create a blank Zephyr project for NRF52 and want to use SES. But I could only open pre-existing samples and there's no way to create a blank project.
Appreciate...
I want to create server and client in nrf9160 not through LTE. only transmit on locally in nrf9160
//prj.conf # enable libs CONFIG_NEWLIB_LIBC=y CONFIG_NEWLIB_LIBC_FLOAT_PRINTF...
Hi support team,
In PS, it stated the sensitivities for ideal BLE transmitter, I would like to know:
o Sensitivity at 1M PHY DLE 255 octets , Dirty Transmitter on
o...
Hi,
In the documentation [1] for 802.11.4 for nrf52-sdk it is mentioned that the documentation is for the nrf52840 soc only. Where can I find documentation regarding 802...
I would like to add FOTA via HTTP to mqtt_simple example
please describe how to do that, and how to test the update
I know I need to add the following modules via...
