At some point in the past I had nrf51+gdb+breakpoints working just fine. I even have a bunch of __BKPT() calls in my various error handlers to trap into the debugger.
At...
Hi,
I'm trying to program nRF51822 Beacon Kit using nRF51DK. I'm trying to load the example ble_app_beacon to the beacon kit. After uploading SoftDevice 7.1.0, I try to...
Hello
I'm using the nRF51 DK and I have a UART over BLE link set up between the board and a phone with the nRF UART app. I'm trying to get the board to execute a particular...
Hello there guys i been reading your 100 pg PDF for awhile now and im yet to understand or realize how is it that i add/place/create a payload or data to send/Tx via Master...
I am interested in writing a BLE central that reads data from multiple BLE Nordic sensors. The BLE central will be running on Embedded Linux which uses the BlueZ stack.
...
Hi,
I'm trying to get S110 softdevice (v8.0.0) working with RIOT. I had some issues (I couldn't initialize TIMER1 or TIMER2 until softdevice is setup & enabled) but I think...
Hello everyone,
I got a task which I try to implement using a NRF51822 iBeacon board.
The Task:
Advertise a Device and provide a mechanism to connect without traditional...
Hello,
I am testing 9 channels for PER (1,2,3,21,22,23,37,38,39). During testing the last 3 channels I always get a single time out error in response to LE_TEST_END. I...
I am having quite a frustrating time trying to make SPI drivers compile into a 52811 project I already started, so I thought I'd back off, and try to just get an SPI example...
Tried to flash ncp .hex for pca10059 on a brand new dongle and now it is stuck in dfu (pulsing red led). The process worked on a second dongle without any issues.
Something...
Running nrfconnect320x8664.AppImage on Linux (SuSE Leap 15.1). Read "Getting Started" but that was of little help!
So, following my nose.. On the Apps tab of application...
HELLO,
I am trying to generate a 125kHz pwm siginal using nrf51802（sdk version12.3）. I use the oscilloscope to observe the wave form.I change the macro value of PERIOD_IN_US...
Hi,
I am developing an app for PCA10059 board. my app works well but after sometime and saving some data on flash, boards keep resetting and did not booted(LD1 blinking...
Does anyone have experience in porting both embedded and android code from the 13.1.0 SDK to 15.x.x?
I'm running into an issue where the system worked fine on 13.1.0,...
Hi,
I am actually tring to migrate a project from Keil to Segger Embedded Studio (SES) and i have a problem with the build of my project when tring to build ecc.c.
The...
Hi,
I have to nrf52832 , s132 modules working as peripheral and central.
I would like to get an idea and input on how to change central mode to peripheral mode.
The...
Hello everyone,
I am having some trouble starting the HFXO crystal manually before using the RADIO to send raw advertisements: the HFCLKSTARTED event never raises. The code...
Hi
I am relatively new to this software and I am using this for a project which involves device-device and user-device communication.I came across the ble relay example...
I have a question about "SEGGER Embedded Studio for ARM V4.12".
When "Build Solution" is executed, "Build failed" is displayed and an error occurs. However, if you do "Bulid...
