At some point in the past I had nrf51+gdb+breakpoints working just fine. I even have a bunch of __BKPT() calls in my various error handlers to trap into the debugger.
At...
Hi,
I'm trying to program nRF51822 Beacon Kit using nRF51DK. I'm trying to load the example ble_app_beacon to the beacon kit. After uploading SoftDevice 7.1.0, I try to...
Hello
I'm using the nRF51 DK and I have a UART over BLE link set up between the board and a phone with the nRF UART app. I'm trying to get the board to execute a particular...
Hello there guys i been reading your 100 pg PDF for awhile now and im yet to understand or realize how is it that i add/place/create a payload or data to send/Tx via Master...
I am interested in writing a BLE central that reads data from multiple BLE Nordic sensors. The BLE central will be running on Embedded Linux which uses the BlueZ stack.
...
Hi,
I'm trying to get S110 softdevice (v8.0.0) working with RIOT. I had some issues (I couldn't initialize TIMER1 or TIMER2 until softdevice is setup & enabled) but I think...
Hello everyone,
I got a task which I try to implement using a NRF51822 iBeacon board.
The Task:
Advertise a Device and provide a mechanism to connect without traditional...
Hello,
I have to transfer 256 bytes over BLE using a nrf51822 with s110 SD. I have used the steps in the guide in this post: devzone.nordicsemi.com/.../ and it works fine...
Hi all,
The ble_app_keyboard demo could not connect to ipad smoothly like followed operation:
1.use two iPads(ios8.2), iPad A and iPad B;
2.use the ble_app_keyboard...
Hello there,
I have a question about compatibility of dongle with ble_peripheral examples.
I have been using pca10028 nRF51-dk running ble_peripheral examples (+S110)...
Hi,
I am using nRF51822 controller for my development. I implemented the system sleep mode as below.
for (;;)
{
power_manage();
}
void power_manage(void)
{
uint32_t...
Hello, I found that there has been SDK update for NRF52 regarding NFC. Currently, it looks like NFC is just used for tagging.
I'd like to know whether I can use NFC peripheral...
Where can I find the BLE_GAP_EVT_ADV_REPORT value if I am using S310 SoftDevice?
Without it I cannot use my client to get advertising data from server. Or is there any other...
Hi Nordic：
I have two questions about SoftDevice s130：
Device A,B,C,D are using s130.
When this device (called A) is a peripheral and connected with a tablet...
Dear Nordic developers!
I am working on a project, which should use the ANT+ and the BLE communications, too. The S310 SoftDevice is good for them, but I have some problem...
Hi
I have been reading a lot of posts and the documentation on DFU for SDK7.2, but something is not really clear to me.
When I compile and program the boot loader in my...
Has anyone added an external power amplifier to the nRF24L01?. For my application, I need to increase rf power.
What about a skywork Amplifier ? if there is any amplifier...
Howdy all,
Has anyone added an external power amplifier to the nRF51822? From what I recall the BLE spec allows for 10mW output power (well, 10mW would be the maximum for...
Is there any recommended chip antenna for NRF52 SoC? Any guideline on the antenna placement, designing the matching circuit etc? I assume for NRF52, no need for an external...
