But now I have a new problem that is whenever I set " PWR_UP " bit in CONFIG register then it drop the 3.3 volt vcc to 1.2 volt. I don't know why its happening. Anyway, is...
This previous question about multiple advertisements seems to be related to softdevice 7. I was unable to get a similar example working in SD/SDK8
My end-goal is to add...
We are considering using Gazell for an outdoor application, i.e. lots of noise and disturbances, constantly changing environment, where the amount data being transferred is...
Hi everyone,
I have found your git "Ble Optiboot"( github.com/.../ble-optiboot) , and I have understood, it is usefull to load a binary into MCU flash, I was looking for...
I'll go ahead and describe what I need to do and see if anyone might have some place to start for me since I'm having a lot of trouble figuring out what I need.
I'm looking...
Hi Nordic,
I am using ESB_DPL SDK ver 13 for communication between one nRF51822 transmitter and multiple nRF51822 receivers with data whitening. I do not want the receiver...
I ported both the provisioner and provisionee program respectively to 2 different boards, but couldn't detect the advertising package of neither.
Do they send exclusively...
Hi all
I've two questions regarding errata 156:
Am I assuming right that, as long as I don't use WFI or WFE, this errata has not effect?
Are the two consecutive...
Hi. I'm using nRF52832.
I want to add LEDs. Can it drive 20mA for LED?
As I see the datasheet, GPIO pins have "High drive" function. What deos it mean?
I hope your reply...
Hello,
I am having difficulty downloading an application using the sample images provided. It looks like the application boots into the bootloader, there is a brief message...
Hi,
I modified the blinky_freertos example from SDK 12 slightly to perform the following:
I have one timer and one task. The task blinks a LED and then suspends. In...
I'm trying use an nRF51 PDK to upload firmware (or, rather, just confirm that I can upload firmware) to one of these modules:
www.wireless-tag.com/.../WT51822-S4AT.html...
Hi,
I am new in BLE and working on existing product. i am adding BLE functionality in the existing product hence having one host MCU on my board. My product will be in...
Hi There,
I am doing current measurements on the nrf52840 in sleep mode with no RAM retention and I am getting different values based on how I take the measurements. Please...
I am attempting to interface a Winbond flash device with the NRF52. The
datasheet does not specify the idle state of MOSI when reading from the device. However, I cannot...
We started with the default project that have no heap.
Added mallocs to the system and they seemed to succeed, without realizing heap was set to 0. They did not return NULL...
hello
we have custom board with Nrf52840.
i already test the uart code on nrf52840 dk..every thing is working great.
my custom board is connect to the nrf52840 dk with...
Hi
I have a PCA10040 V1.1.0 that my company has been using to flash test code onto other nRF52832 chips (I don't know the details, but it has wires attached to the debug...
Hello,
I am using the BLE_app_hrs_pca example and I was wondering whether or not the unit in which my beat rate is encoded (bpm) can be changed. I mean, I would like to...
