Hello,
I would like to do an communication between Arduino and Android platform.
In my case, Android will be master.
But I want also test between 2 Arduino with an Bluetooth...
Hello,
I would like to develop a custom key sharing algorithm for nRF8001 chips. As far as I have understood the only way to use full 128-bit temporary key (TK) is OOB...
i am useing nRF51822 pairing with nRF24lu1 over GZLL protocol now,
is there someone have the experience on how to config the parameter of GZP_TX_RX_TRANS_DELAY in function...
I have a peripheral running the S110 stack, which presents a characteristic to which I want the central (running S120) to be able to do a long write. What I've been trying...
Hi all,
I have been trying to combine the UART and hID Keyboard examples into a single application.
I want to use the HID part to send specific keystrokes using buttons...
Hi, I'm new to BLE and just started feasibility testing, using RF8001, on a small device with no IO. The device will have a unique code set at factory, and printed on label...
I did current measurement on nRF5340 DK with PPK2 kit.
I’m using the Ampere Meter Mode, and cut the SB40 on nRF5340 DK.
Test Setup: Ampere Meter Mode
Window Testing...
Hello All,
I am just facing an issue w.r.t monitoring the ADC pin with certain threshold voltage. I am able to read the voltage level using SAADC driver on that pin and...
Hi
In my app i need to keep in sync client/server communication, which means no packet is sent in any direction until the sender got the confirmation from receiver for the...
I can't see any headers for this board and MCU in the current 17.0.2 SDK. Are board headers available anywhere yet? Should that be pca10095.h or something else?
Thanks...
Hello all i want to do a task that is control another LED using ble_app_blinky. In the ble_app_blinky project a characteristic is used to control an onboad LED. I have connected...
After 3 days of debugging and hours on the forums trying out various things, I just wanted to post a mini quick start guide to getting low power working. Turns out that all...
Hi Guys，
I want to implement a Vendor-defined USB HID device, But encountered the following problems:
1.When the PC sends data via USB HID , the slave(52840) cannot enter...
Since SDK15.3.0 the DFU example code has changed to require signed DFU commands.The DFU that we used is base very closely on the Nordic example. In our update process we have...
Hi,
I am facing an issue with the RSSI value when my device is in connected mode.
First, in ble_evt_handler(),
in the BLE_GAP_EVT_CONNECTED case, I place the following...
Hi I am using NCS version 1.5.0 and DK version 1.0.0
If I want to build any application using nrf9160dk_nrf9160 Im getting the following error.
Traceback (most recent...
Hello, We are about to release a Firmware update for our vibration sensors and we are now testing the consumption of the new firmware. Our sensor is a nRF51822 + Accelerometer...
