Hi I've got my nRF8001 breakout board ready I now need the SDK in order to start developing firmware code.
I don't have any registration key, how do I get hold of it? ...
Hi,
I'm running Mac OS X 10.10.2 with the nRF51-DK PCA10028 card that I received today. I started off following the instructions in this article , and was able to get JLinkExe...
Hello,
I would like to do an communication between Arduino and Android platform.
In my case, Android will be master.
But I want also test between 2 Arduino with an Bluetooth...
Hello,
I would like to develop a custom key sharing algorithm for nRF8001 chips. As far as I have understood the only way to use full 128-bit temporary key (TK) is OOB...
i am useing nRF51822 pairing with nRF24lu1 over GZLL protocol now,
is there someone have the experience on how to config the parameter of GZP_TX_RX_TRANS_DELAY in function...
I have a peripheral running the S110 stack, which presents a characteristic to which I want the central (running S120) to be able to do a long write. What I've been trying...
Now facing the problem "After disconnected, the electric current increases"...
I think softdevice is working hard even after disconnected when connecting once.
Could you...
Hi,
I'm trying to write unit tests and have arrived at the point to write tests for ble characteristic addition to a service.
To offer some background, I have written...
Hello,
I use NRF51822 and I try to output UART message onto hyperterminal program.
but every message I send it contains "APP:INFO:" in front of the message.
like...
I want to use nRF Connect v2.1.0 to debug.
But i faild to connect the correct J-link because the nRF Connect choose the wrong J-Link IDs on the COM. So i can just change...
I'd like to use nRFConnect with a direct USB/Serial connection to my nRF52832-based device. I've read that it currently checks the jLink chip.
Is there any way to configure...
Hi,
I am using Keil IDE to develop nRF51822 project.
in main(), the command line
APP_SCHED_INIT(APP_SCHED_MAX_EVT_SIZE, APP_SCHED_QUEUE_SIZE);
has Error : L6218E...
Hello,
for multilink client services Nordic introduced the *_EVT_DISCOVERY_COMPLETE events and the *_c_handles_assign functions. Like the BLE_BAS_C_EVT_DISCOVERY_COMPLETE...
Hey
Would 3++ nRF51822 bluetooth smart beacon Kit sense in location application where lets say 2 beacons are quite close by (half meter) and third, the locatable beacon...
Hello,
I have modified my device name (nRF52, BLE) per the function below. When flashed to a board, I then use nRF connect to look for this device.
Using Windows nRFConnect...
I'm having an issue when trying to perform sequential reads with the ADC on 4 different pins. I've setup a timer to trigger every 1 second. In the Timer0 IRQ I setup the ADC...
Using SDK v12.2.0 . Starting a new project with Segger Embedded Studio, I have to assemble an sdk_config.h file. For example when using GPIOTE I first need to find an example...
Hi,
I am using ble mesh sdk 0.9.2 light control sample where I have modified it to send messages from the client to one particular server every 5 seconds.
Now I am trying...
Hello, I've got an nRF52832 on a custom board and I am unable to perform an SAADC calibration correctly.
I'm using SDK14, SD212 v4.0.2., and my main application code broadcasts...
