Hi,
I'm running Mac OS X 10.10.2 with the nRF51-DK PCA10028 card that I received today. I started off following the instructions in this article , and was able to get JLinkExe...
Hello,
I would like to do an communication between Arduino and Android platform.
In my case, Android will be master.
But I want also test between 2 Arduino with an Bluetooth...
Hello,
I would like to develop a custom key sharing algorithm for nRF8001 chips. As far as I have understood the only way to use full 128-bit temporary key (TK) is OOB...
i am useing nRF51822 pairing with nRF24lu1 over GZLL protocol now,
is there someone have the experience on how to config the parameter of GZP_TX_RX_TRANS_DELAY in function...
I have a peripheral running the S110 stack, which presents a characteristic to which I want the central (running S120) to be able to do a long write. What I've been trying...
Hi all,
I have been trying to combine the UART and hID Keyboard examples into a single application.
I want to use the HID part to send specific keystrokes using buttons...
we have used the NRF51822-BEACON KIT EVAL BLUETOOTH SMART BEACON which includes RGB LED, but cannot find a non dev kit model with RGB LEDs . can you recommend one with either...
I am using NRF52 SDK14.0 and SoftDevice S132 v5.0.0. I am using GPIOTE low level port interrupt to wake the system from SysOff mode. If SoftDevice is enabled and I put the...
Hello,
On Nordic Studio, there is a fairly well documented NUS (Nordic Uart Service) that provides a read and write characteristic, and it mimics uart. Data written to the...
I have a BLE device "Masimo" and I'd like to download its data in real time through BLE notifications.
This device comes with an Android App which is able to download the...
Hello,
I have a problem with writing to server characteristic (battery service and custom). sd_ble_gattc_write function returns 0x11 which means another write with response...
Hello,
I am using sdk12.2.2 and pca10040. I want to add uart drivers in ble_app_template code so that I can use printf to get my data on terminal. Unfortunately I am not...
I AM USING SDK 12.2 AND IT IS RECOMMENDED TO USE FSTORAGE. But i found no function to read unlike pstorage_load . so can i use pstorage instead of fstorage will it cause any...
Dear Helpers,
We are facing an issue. It is all related to DFU (secure buttonless) and Android 7.0 (deployed on a Samsung A5).
We have a code that is running perfectly...
Hi
By playing around with the serializer code for the S132 5.0.0 I found a bug in the serializer/deserializer code.
The ble_gap_evt_auth_status_t has a new field "lesc...
I'm using FreeRTOS in my project and I wanted to check if the APP UART FIFO implementation is thread safe, IE I want to have a reader and writer thread. Each FIFO has a separate...
I want to enable BLE's NUS Service(in Old SDK, nRF5_SDK) with in nrf5_SDK_for_Mesh.
Is it possible?
I'm failing, as starting of this, to use Softdevice for parallel use...
I HAD ASKED THIS QUESTION: we have used the NRF51822-BEACON KIT EVAL BLUETOOTH SMART BEACON which includes RGB LED, but cannot find a non dev kit model with RGB LEDs . can...
Hello sir,
I have develop project and their lots of quantity. I want flash my updated program into my nordic device without open this device via BLE services. Is it possible...
Found on the web:
"Properly configured WiFi network shouldn’t interfere with the Bluetooth signal. The best practice for WiFi configuration is enabling WiFi on one of the...
