Hi I've got my nRF8001 breakout board ready I now need the SDK in order to start developing firmware code.
I don't have any registration key, how do I get hold of it? ...
Hi,
I'm running Mac OS X 10.10.2 with the nRF51-DK PCA10028 card that I received today. I started off following the instructions in this article , and was able to get JLinkExe...
Hello,
I would like to do an communication between Arduino and Android platform.
In my case, Android will be master.
But I want also test between 2 Arduino with an Bluetooth...
Hello,
I would like to develop a custom key sharing algorithm for nRF8001 chips. As far as I have understood the only way to use full 128-bit temporary key (TK) is OOB...
i am useing nRF51822 pairing with nRF24lu1 over GZLL protocol now,
is there someone have the experience on how to config the parameter of GZP_TX_RX_TRANS_DELAY in function...
I have a peripheral running the S110 stack, which presents a characteristic to which I want the central (running S120) to be able to do a long write. What I've been trying...
I am using SEGGER Studio on MacOSx.
When use the latest mesh SDK, I can run the light_control example and see the debug log in the Debug Terminal of SEGGER Studio.
However...
I have the test that spi communication between nRF51 DK(Master) and nRF52 DK (Slave).
use the example projects in SDK 12.2.
success build and writing but i have got...
I would like to utilize six Sampo S1 readers (yes, I only read for now, I know they can do much more) to count people entering and leaving a conference.
I am looking for...
I implement it with sdk 11.0 and a third party board.Firstly,I program s132_nrf52_2.0.1 SoftDevice by nRFgo Studio，secondly，i program dfu_dual_bank_ble_s132_pca10036. then...
Hi experts
I am trying to interface an external ADC to NRF51-DK i am presently reading SPI ADC code values on BUTTON press event. I am able to read the values from ADC...
Post in reference to link
After flashing light control server or client app on PCA10028 app crashes with HARD FAULT.
Steps how I built the app:
Using freshly downloaded...
Hello,
I find that some examples such as ble_app_uart uses a GATT_MAX_MTU_SIZE of 158, and it has initialization in function ble_stack_init().
// Configure the maximum...
Hi. I'm using nRF52832. I need more GPIOs and UARTs. So I think nRF52840 is very good solution to me.
But as I know, nRF52840 is just engineering sample now.
When can...
I am running the Iot SDK Cloud MQTT example on a nrf52 DK. Is there are reason why MQTT will only let me subscribe to a maximum of 9 topics. Anymore and some of the topics...
I'd like to get the current connection state eg:
result = get_connection_state()
if(result == BLE_GAP_EVT_CONNECTED)
doSomthing();
Is there such a function available...
Hello,
I'm trying to setup a nRF Cloud Bluetooth gateway using my PC (with openSuse 42.2 64bits and rRF Connect v2.1.0 + nRF Cloud Gateway v0.9.7) and a nRF52 DK and I...
I am working off the ble_cts_c example, using SDK 14.0.0, SoftDevice S140, and nRF52840.
All works well when I pair a device for the first time: the nRF discovers services...
