Hi I've got my nRF8001 breakout board ready I now need the SDK in order to start developing firmware code.
I don't have any registration key, how do I get hold of it? ...
Hi,
I'm running Mac OS X 10.10.2 with the nRF51-DK PCA10028 card that I received today. I started off following the instructions in this article , and was able to get JLinkExe...
Hello,
I would like to do an communication between Arduino and Android platform.
In my case, Android will be master.
But I want also test between 2 Arduino with an Bluetooth...
Hello,
I would like to develop a custom key sharing algorithm for nRF8001 chips. As far as I have understood the only way to use full 128-bit temporary key (TK) is OOB...
i am useing nRF51822 pairing with nRF24lu1 over GZLL protocol now,
is there someone have the experience on how to config the parameter of GZP_TX_RX_TRANS_DELAY in function...
I have a peripheral running the S110 stack, which presents a characteristic to which I want the central (running S120) to be able to do a long write. What I've been trying...
Hi,
We modified the lte_ble_gateway example and connected to our aws iot server. And have faced few issues so far and would like to get some hint from you.
We are using...
This question was asked, not answered, and locked. So I will ask it again
I changed the security settings on a CCCD for a heart rate measurement characteristic and got...
Hello,
I have troubles with the timer interrupt. The code work fine until the timer hit the compare value and then stop.
This is my function for the timer init:
Here...
Hi,
I have a problem with the BLE mesh light example using the static provisioner. I have modified the example to have multiple Generic OnOff servers. Client and Servers...
Hi, I'm a beginner of Firmware Engineering and facing an issue on programming of sensor module.
I am using a sensor as IIS2DLPC made by STM, and board is nrf52840 dk board...
I am re-starting a project to send MQTT topics to AWS. At this point, is MQTT_Simple still the best way to start and then modify the endpoint as suggested in case 224855 or...
When i call the sd_ble_gap_adv_start function then after a few seconds the mesh communication fails because the scanner_radio_irq_handler is not called/triggered anymore....
Dear,
I started a new laptop Windows 10 Pro
installed nRF Connect, and followed the Started Assistant
installed the toolchain
downloaded the SES (v4.20a)
----...
I have NRF5252840-DK (evaluation board, SDK 15.3.0, S140) acting as central. It correctly scans advertising data from my peripheral - custom board with NRF52811 (same SDK...
Hello,
I am working on nRF9160 DK development platform.
For that i Compile & run GPS example, But while debuging that example i find that mcu stucks in CPU Idle function...
Hi,
I am currently trying to program an external module using the nordic nrf52840 development kit debug output pins. I have the following connections that I have taken from...
