Hi, could you please tell me if my assumptions below correct?
Measuring a (ratiometric to VCC) analog signal and selecting VDD_1_2_PS as the reference selecting AIN_NO_PS...
When I initialize the SoftDevice with SOFTDEVICE_HANDLER_INIT(NRF_CLOCK_LFCLKSRC_XTAL_20_PPM, false); // Sets up Crystal Source to 20ppm 32.7628kHz
The project I based...
I am trying to make a product with NRF8002B. I finally have the product prototyped. The user will connect to the device, beep, light up, and track. It will always stay on...
Please,
It seems that "Flow Control" signal is not available on nRF24AP2-USB.
EVENT_TRANSFER_TX_START event message appears only one time after the first data packets...
I am looking for cheapest (up to few hundred USD) and simplest Arduino basic solution to track real-time RFID tags distance (also direction if possible) without additional...
Hi all,
I am new to Nordic semiconductor but I could be interessed by nRF9E5. To check if it could fit my requierement, I would like to know if it possible to configure...
I want to place a IoT application on an Application chip and connect it to a Connectivity chip running the BLE IoT SoftDevice.
Does the nRF5 IoT SDK support serialization...
Hi Guys,
I know this is more for software issues. But I was curious as to where I can find trusted case providers/makers for the nrf51822 Beacon. Can anyone from the community...
Hi,
I am coding a Sharp memory LCD display using SPI and the nRF51422 development board.
I have tested the SPI connection using a logic analyzer and signals are being...
I will start doing a custom PCB (1.3cm diameter) with a nordic BLE, any recommendations about the components needed and design?. I need to use mbed programing tools, any experience...
Hi,
After training on a PCA10028, i want to develop on my personal board.
I use keil but i saw a problem.
The libraries are all in folders of folders in the sdk folder...
I don't know why I didn't notice this blurb in the reference manual sooner. In pretty much all peripheral sections (such as SPI), you have this warning:
Therefore, the...
When loading the ble_app_uart_s130_pca10028.hex file (Windows 10)
from nRF5_SDK_11.0.0_89a8197/examples/ble_peripheral/ble_app_uart/hex using nRFgo Studio - Program Application...
Hi,
I programmed the NRF51-dk to take ADC samples and transmit those values at 8 bit resolution. Now I want to send a 10 bit resolution value over BLE UART, but I believe...
Hi everyone,
In my low power application , I use PORT EVENT to detect the interrupts of my two pins.
when I use only one pin interrupt, it's working well .
But with two...
Dear All,
We are implementing 8 Pheripheral Nodes and one central node with S110 and S120 respectively.
We have our custom board with us we are able to connect the pheripheral...
