Hi all,
I am new to Nordic semiconductor but I could be interessed by nRF9E5. To check if it could fit my requierement, I would like to know if it possible to configure...
Hi,
I am using ADC without external reference and no analog input in order to measure the battery level with a timer (code at the end).
I am also reading several ports...
Hi,
I'm programming the nRF51822 and save some user data into the FLASH by using pstorage_update . It works fine if I set system off mode, and wake it up. I can read back...
Hi,
I have been using nRF51822 with my Android app using Android's Bluetooth Low-Energy APIs.
In order to get more details, I am currently working on integrating the Android...
I'm looking at interfacing a typical Wheatstone bridge sensor to the nRF51822 ADC. This particular sensor only requires a mA or two for excitation and the output fits within...
When use the "nRFBeacons" app to update the info on my beacon the following happens:
Go to update tab.
Select "Connect"
Press "SW2" on beacon and see the LED begin flashing...
I am using s110 and nrf51822. I've set up up a long characteristic of 154 bytes.
Sending between 1 and 154 bytes works as expected.
Sending 155 - 160 bytes gets rejected...
When using the nRF51822 as a Bluetooth Smart (BLE) emitter, is it possible to change the UUID, Major or Minor values by hardware (for example, by changing the digital input...
Hi, student here, so go easy if you can :)
I have successfully programmed the evaluation kit and development with the softdevice and loaded my app on.
Now I am trying...
Hello there,
I have read about SoftDevice and how it uses EMA to send and receive information over the air. However I am quit confused about what a ble stack is. Could you...
I have an issue trying to set up an example project following this guide .
Despite the makefile including correct paths in the INC_PATHS variable, none of the headers included...
Hi,
I have implemented some code to periodically switching back and forth between the normal and the config mode. I can see that the handler function is being called, but...
Hi everyone,
A beginner here with an idea for a small project.
Project specs: 4 BLE buttons paired to a Android or iOS phone and an app that will listen which button has...
I am working on "nRF51_SDK_8.1.0_b6ed55fnnn\examples\ble_central_and_peripheral\experimental
\app_s130_demo\pca10028\s130\arm4" project .
In this project,in which variable...
Or is there any LCD you could suggest that doesn't need that much code? Simple numeric 2rows would be enough. Want to use it with the nRF51-DK to display some measured valued...
Scenario: I want to use an Arduino shield with the nRF51 DK. When attached to an Arduino, the Arduino's barrel jack is plugged into a 12V power supply. The shield takes advantage...
I am working on a ble project using the nRF51422 and IAR. I can load the code onto the board from IAR and it works as expected, but I run into errors when I run the code with...
