Hi,
I use two evk board to connected and test the uart serialization sample(ble_s110_serialization), one is ble_app_hrs and one is ble_app_connectivity. But I have one...
I am getting get BLE_EVT_USER_MEM_REQUEST and BLE_GAP_EVT_CONN_PARAM_UPDATE event, when writing to ble device, sample code did not handle these event, and seems no document...
Hello:
Why do I erase SDK5.2 version of flash and read not, in SDK4.2 can. I tested nrf51_sdk_v5_2_0_39364\nrf51822\Board\nrf6310\flashwrite_example is a good example.However...
before i write the flash, it has been erased.so ,its value is all 0xff.
when i write 0x00 to flash address 0x0001,the value read out is not 0x00 but 0x01,and the value in...
I'm looking for a way to use the nordic uart service ( devzone.nordicsemi.com/.../ble_sdk_app_nus_eval.html) from Linux using the native Linux BLE Stack (BlueZ). My application...
Hi,
I've created an application using the S110 experimental ANCS demo. I successfully implemented ANCS and then began to structure my application around it. At some point...
I have my radio chip set up so that it pairs with an iOS device via an encrypted bluetooth connection. Everything works great -- however I'd like to be able to "unpair" from...
Hi,
we are using the chip nRF51822 CEAAE00.
We want to use the pin 0 as output. It is configured as below
NRF_GPIO->PIN_CNF[0] = (GPIO_PIN_CNF_SENSE_Disabled << GPIO_PIN_CNF_SENSE_Pos...
Hi,
I using nRF51822, S110 and NUS to send the data to the phone.
When sending the data, I using ble_nus_string_send function.
I need the execute time to the phone...
When scanning for peripherals using the Master Control Panel Android app, most of the various BLE devices scattered around me show up with a "connect" button next to them...
I have a development board with the AC variant, but for my custom board I have an AB. I am able to flash code using Keil to the development board, but when I change the device...
Can anyone suggest an I2C LCD driver for use with the nrF51822? We will likely be driving a 96-segment LCD but a dot matrix LCD may be an option.
The application is for...
I get the following error on doing OTA DFU using an Iphone with IOS V8.4.
Created .zip files using nrf.exe
Commands used
nrf dfu genpkg --application...
Hi everyone,
We're working with nFR8002 devices, and it works fine most of the time.
Even after losing the link intentionnally (Bluetooth stopped, or walking out of Bluetooth...
This question devzone.nordicsemi.com/.../ appears to show that S132 expects the FPU to be available and activated.
Does the S132 really need/use the FPU or is this an artefact...
Hi,
I know that when advertising in non-connectable mode, the fastest advertising interval is 100ms. I have some questions about this:
Is there any document explaining...
I have been using NRF51822 for some time as BLE chip with services.
For some debugging reasons I need a faster stream method...
I looked at Gazell and found it simple to...
Hi, I have a question about this memory layout .
At Figure 2 (of the memory layout), it erases the previous application.
After that, at step 1, it says that the firmware...
