But now I have a new problem that is whenever I set " PWR_UP " bit in CONFIG register then it drop the 3.3 volt vcc to 1.2 volt. I don't know why its happening. Anyway, is...
This previous question about multiple advertisements seems to be related to softdevice 7. I was unable to get a similar example working in SD/SDK8
My end-goal is to add...
We are considering using Gazell for an outdoor application, i.e. lots of noise and disturbances, constantly changing environment, where the amount data being transferred is...
Hi everyone,
I have found your git "Ble Optiboot"( github.com/.../ble-optiboot) , and I have understood, it is usefull to load a binary into MCU flash, I was looking for...
I'll go ahead and describe what I need to do and see if anyone might have some place to start for me since I'm having a lot of trouble figuring out what I need.
I'm looking...
Hello,
I'm just getting started with my nRF52832 and I am still trying to get the first example of the tutorial page running ( Getting started with nRF5 DK .
I did everything...
Hello,
I am doing a project that involves getting data from 2 PTX nodes from the slaves via ESB and sending the data obtained to my android phone via BLE. I am doing so by...
Hi,
We have created a new button events for our application in which it will record total time/ticks that the button is presses.
When you press button for 3-4 sec BLE...
Hellow,
I am trying to add different UUID bases for every characteristic.
I add the service like this:
uint32_t ble_service_init(ble_t * p, ble_write_handler_t write_handler...
I see at infocenter.nordicsemi.com/index.jsp a note how:
Missing feature: Serialization of the latest S132 SoftDevice v3.0.0 API (work in progress)
My questions...
Hi All,
It seems that my question may be repeated but I went over almost all similar posts and followed the suggested resolution, however no luck :(
I downloaded the...
Hi,
I have used a modified ble_uart example. I have added 14 extra characteristics in that example. When I have the device name to be 'devic NM' the number of attempts to...
Hi,
I would like to use nrf51822 chip with 128kB flash. My application was made based on the template version which is attached in SDK v11.0.0. Only blank template version...
I'm using the nRF52. I started off with SDK11.0.0 and noticed that SDK12.0.0 is available. It seems that the GPIOTE IRQ priority has gone from 2 to 6. Any reason for this...
Not a question, reporting a typo. InfoCenter "nRF52832.Product Specification.RADIO.Packet configuration" about the sixth paragraph "The S0INCL field in PCNF0 determines if...
Hello,
When I use the .hex of the tutorial, works ok. But when I compile the tutorial works Ok until when it suppost to sleep (after the timeout time), then gives an error...
I'm working on my owm dfu service and until recently I used pstorage_raw for handling memory. Now as I wanted to implement bonding, I added the peer manager, because I'm not...
What are the expected wait states when reading data from RAM and FLASH on the nRF52? This is stuff on the DCODE bus.
What I'm seeing whilst profiling is a load instruction...
