Hi!
I've been using PCA10028 for a long time and I had some bricking issues but I've managed to un-brick it with "nrfjprog --recover" and everything would work again. ...
I want to build nrftoolbox app in android studio. I downloaded the zip file from the github website and also the required dfu library. I unzipped both the files in a folder...
Hello,
I have a device based on nRF51822 revision 2 and SoftDevice S110 v7.1.0. Because it is revision 2 it is affected by PAN44 and PAN45, and by default the SoftDevice...
Hi Guys,
I know this is more for software issues. But I was curious as to where I can find trusted case providers/makers for the nrf51822 Beacon. Can anyone from the community...
Hi,
Has anyone converted the Adafruit graphics library for Arduino, Adafruit_GFX.h, to be compatible with the nRF51?
Could you please advise on how to convert this Arduino...
Hi all,
I have a few questions:
How is that ADC's common mode rejection capabilities? Rejection for 60 Hz interference, etc...
The datasheet has "typical...
Hello.
I m working with mesh demo: https://github.com/NordicPlayground/thingy52-mesh-provisioning-demo
In Android app we can press "identify" and after that Thingy's led...
Hi, On a button press I need to enter to disconnect from the currently connected device and then start advertising in order to allow a new device to connect. I manage to disconnect...
I am trying to read analog value from a GPIO pin. Particularly I want to read battery voltage from a GPIO pin assign to P0.31. Please help me how can I read the analog va...
Dear All,
Thanks for your continued support.
I have been trying to get debug terminal to work... I enabled RTT log and disabled UArt in the sdk_config file. I set...
Hello!
I'm trying to handle an interrupt using a timer.
Is it okay to write something like the following?
Also, if this is called every 1ms as interrupt processing...
Hello,
Im using D52Q ANT Module series chip, I have uploaded the S132 soft device and BLE peripheral program(PCA10040).
Once i download the program, 3rd LED glows, and...
Hi everyone,
I'm working on a project where I need to send sensor data from multiple sources to a PC. So, I'm using multiple SparkFun Pro nRF52840 Mini board (Peripherals...
Hi,
I'm using SDK v3.2 and I'm extending the lighting example. I'm developing an extension to the provisioner, to inform a back-end about the configuration of the subnet...
Hi,
our device has current limitations in the range of 1mA. We were examining several ways to limit the actual connection parameters to keep current consumption low. But...
Hi,
I'm developing an application to monitor the current application and network context, by extending upon the existing Light Switch example in nRF5 for Mesh SDK v3.2.0...
Hi everyone !
I have 3 services and 13 characteristics in my project. Until today, 3 characteristics were working fine. But i added rest of the characteristics and my project...
Hi all,
I am currently using Pyaci serial to establish and test BLE mesh network, and it work fine.
The further step we want to do is to create a duplicated Provisioner...
I have a Thingy52, but no DK. I would like to know if it is today possible to upload a custom firmware only using OTA (no DK), eventually starting from the Nordic Thingy app...
Hi,
I'm trying to transfer data between an nRF52840-DK and an Android phone which has nRF Connect installed on it and I can only reach about 40kbps (that is kilo bytes per...
