Hi All,
I'm using nRF24L01P for TX device and want to receive packet from nRF51822 RX device.
nRF24L01P TX device Register settings are as follows;
Reg.EN_AA=0x00...
I am trying to develop for some nRF51822 mbed boards, and I would like to use the S130 SD to enable both central and peripheral behaviour. The machine I'm using for development...
I'm using the nRF51822 eval kit
I have installed MCP but after starting I get pop-up: Master Control Panel has stopped working
In nRFgo Studio / Device manager pane...
the proximity example is running ok. but when I modify the length of the alert_level I have the following error on the server side that I am not understanding.
476;16:12...
Hi all,
I'm working with the nrf51422 and the nrf51822 and I was wondering what the current status of the over the air DFU system is.
I'm using SDK 6.0 and I managed...
nRF24l01+ at a transmitter module one time successful transmission show & after 1 sec failed also . if any doing programming with atmega32 ,please send code for TX & RX ....
Hello,
can the radio notification and radio disable APIs be used to use the radio hardware from the application layer?
Background of my question is, that I have an application...
Hi,
in order to find out how Android nRFToolbox App works, I downloaded Source Code on:
https://github.com/NordicSemiconductor/Android-nRF-Toolbox/releases
I unzipped...
Hi,
I am using nrf_gpio_port_read to read port 1 (pins 8-15), and I want to know how long it takes to read the port, ie. how many instructions. I am doing this in an interrupt...
I have a need to maintain current state of my device along with other parameters, including temperature and hours used. If I update my pstorage page frequently, like once...
Hello,
I'm working on S110 peripherial <-> S120 central project using GATT. I have succesfully implemented S110-based peripherial device with some custom characteristics...
Hey All,
I am trying to create a simple data transfer system using a DFRobot Bluno (CC2540 chip) as the central device, and a Redbear Labs Blend (nRF8001 chip) as the peripheral...
Hello all,
In many thread I can read that it is not recommended to use the internal DC-DC converter to supply the nRF51822.
Can you tell me why it is better to use an...
Greetings all -
We have an nrf51-dongle for development and testing purposes, and are unable to connect to the device over USB with any of the Segger or Nordic tools. I...
Due to BLE's low range, license costs and unneeded complexity, I am looking in to pure radio RF. I am curious about ESB and Gazelle, and which one is good for relatively simple...
Testing OTA using nRF Toolbox on Android. Everything works fine, but for some reason the file selection is "stuck" in dropbox, i.e. I can not go up a level from dropbox, and...
my development environment is nRF-DK and IOT SDK
Q1 : IOT SDK Support Gatt Profile?
Q2 : IoT SDK Support DFU mode?
Q3 : in ipv6 coap server example, how i broadcast...
Hi!
I have custom board with nRF51822 and I need to communicate with serial flash W25X40 using SPI master example with SoftDevice enabled (S110 is used). I worked with...
Hello Everyone
i am using LINK LOSS service i would like to send notifcation to the peer device if the connection is lost and also if the connection is made between two...
