When use the "nRFBeacons" app to update the info on my beacon the following happens:
Go to update tab.
Select "Connect"
Press "SW2" on beacon and see the LED begin flashing...
I am using s110 and nrf51822. I've set up up a long characteristic of 154 bytes.
Sending between 1 and 154 bytes works as expected.
Sending 155 - 160 bytes gets rejected...
Hi,
I tested the nrf beacon application, it allows only the beacons with company identifier 0x0059 (nordic's id). But i need to modify it to support all the device, how...
I use a app_timer_create() function to create a task(200ms once)
when in the task_timeout_handle() ,
I do something more than 200ms,
what will this timer going ?
Hi!
I use nrf51-pwm-library ( github.com/.../) to control brightness of LED RGB light source and it works ok till I don't want to adjust brightness slowly (dimming function...
hello,
are there any completed sample code of using pwm0, 1?
just 2 or 3 word can working like following? or need other config?
pwmcon=xx;
pwmdc0=xx;
pwmdc1=xx;
also...
I am planning to migrate to SD 7.0 and SDK 6.0 in order to use the static pass key capabilities. When using the static pass key how should security params be initialized ...
I am looking for details on the internal temperature sensor on the nRF51822. I would like to use it to get a general ambient reading of the air around the device. Basically...
I want to get RSSI between PCA10001 and PCA10000. As you known, I have to make these two device connected first. If I write my code based on the example of UART, are these...
Hi,
i need to start my application while pressing two seconds a button. For this i use an gpiote event like here --> devzone.nordicsemi.com/.../how-to-use-app_timer_cnt_diff_compute...
hi everyone.now i am developing a project with nrf51822.i am using the PCA10000 dongle to see some information of advertising packages. i moved out and pluged in the PCA10001...
I'm attempting to load the ant-fs reference design to two different nrf51422 evaluation boards. The application builds successfully but I am having difficulties loading it...
Hi
my application is a 9-axis battery driven motion sensor with a data rate about 144 bit per packet at 1000Hz i have to transmit over air. Low latency (<10ms) is extremely...
Hi,
is there any Example to use the UART ?
I need an monitor while the application is running, is the UART COM Port the right one for this?
Is there an example with...
I need a mutex and I found this information at the ARM site: infocenter.arm.com/.../index.jsp
Is there anything I should be aware of in using this technique to implement...
I have a central device , that acting as a gatt server. the service is customize, and 128bit- primary serivice UUID ,its characteristics' UUIDs(128bit) are all known, how...
How are the four RAM banks divided up in the nRF51822? Is it an even split of the 16K total RAM (i.e. 4K per block)?
Furthermore, can I expect strange results if I turn...
Hello, sirs.
My question is how to configure clock in gazell protocol on nRF51822
I look at the example gzp_dynamic_pairing but that does not have a code part of modifying...
