Hello, I have established the connection between two pca10001 boards, one as central and one as peripheral using multilink_central and multilink_peripheral. I have serial...
Hi,my friend,
Now,I use nrf905.Situation is as follows:
I use the NRF PCB circuit of data manual.Nrf905 work, often loss of data.
1.The Product host is to use the stick...
Hi,
I want to use the Blend Micro with more security. I want use a passkey for the Bluetooth connection. For example through the iOS Device.
Is it possible? Static passkey...
How do I receive multiple signals simultaneously at a single receiver (433MHz) with multiple transmitters ?
I am working on a polling system. This one is similar to the audience...
Hello,
I established a connection between my central and peripheral module. Now i want to write characteristic value on peripheral. I tried with sd_ble_gattc_write function...
I am using the NRF24l01 for my products and looking to buy in bulk(100-1000). Now I know where to buy the just the IC but antenna design is a hard point to break right now...
Hi, my friend,
I've been with nrf905. I use a 16-bit CRC check.
But I encountered problems in use:
1.Nrf905 16-bit CRC check format is CRC-16(IBM):X16+X15+X2+1 or other...
Hii all
I am trying to run bootloader_signing example from the gcc. Nordic already gave an example for Keil I wanted to port the same thing for gcc. But its not working,...
Hi
I'd like to know three type of ESD models breakdown voltage lower limit.
・Machine model(MM)
・Human body model(HBM)
・Charged device model(CDM)
If nobody have the...
Hello,
i am working with the nRF52 DK and the SDK11. My intention is to receive arbitrary bytes via UART in non-blocking mode.
I have already read the following entry...
Hi I need use s130 softdevice as a central. So i am getting error with my existing code that works fine with s120 softdevice as central.
nordic_sdk_10/components/softdevice...
Hi, Nordic:
I'm testing the DC/DC function as to reduce the radio current. I have done the DC/DC test using pca10028 DK with the code below (SD v2.0.1, SDK11) :
void...
Hi,
I want to develop an ANT+BLE application using the D52Q module. I found the BLE serialization documentation but it's referred to S130, S132 SoftDevices. Is it compatible...
I have recently started getting the following error during a DFU using MCP.
Capture.PNG
Any idea as to the cause of this? What is the best way to debug this?
I am...
Hi,
I am wondering why PSTORAGE_NUM_OF_PAGES is by default set to 2 in the DFU project.
From what I understand the pstorage_raw.c module is used to update bootloader...
In iOS, it is possible for different apps to send data to the same characteristics in the same device by calling retrieveConnectedPeriphrals… Is there a way to identify the...
Hello,
currently, I am trying to get the SPI (master with EasyDMA) to work. I interfaced it with an LED driver IC , which needs some signaling (via GPIO pins) along with...
Hi,
I'm using the nrf52 board with sdk11.
I want to know that i have 100 beacons and my nrf52 is a cenral.
1)How many beacons can scan by the central at a time?
2...
Hi, I have managed to get my nrf51822 DK kit to read LDR sensor values. However the characteristic values are represented as hex on the master control panel and also on the...
Hi,
I'm i'm sniffing the NRF51822 s110, using the Nordic's BLE sniffer (on s120).
The BLE device is in a connection, and do a connection parameter update to a new interval...
