I'm looking at interfacing a typical Wheatstone bridge sensor to the nRF51822 ADC. This particular sensor only requires a mA or two for excitation and the output fits within...
When use the "nRFBeacons" app to update the info on my beacon the following happens:
Go to update tab.
Select "Connect"
Press "SW2" on beacon and see the LED begin flashing...
I am using s110 and nrf51822. I've set up up a long characteristic of 154 bytes.
Sending between 1 and 154 bytes works as expected.
Sending 155 - 160 bytes gets rejected...
Hi,
I tested the nrf beacon application, it allows only the beacons with company identifier 0x0059 (nordic's id). But i need to modify it to support all the device, how...
I use a app_timer_create() function to create a task(200ms once)
when in the task_timeout_handle() ,
I do something more than 200ms,
what will this timer going ?
Hi!
I use nrf51-pwm-library ( github.com/.../) to control brightness of LED RGB light source and it works ok till I don't want to adjust brightness slowly (dimming function...
hello,
are there any completed sample code of using pwm0, 1?
just 2 or 3 word can working like following? or need other config?
pwmcon=xx;
pwmdc0=xx;
pwmdc1=xx;
also...
Hi,
we are using the chip nRF51822 CEAAE00.
We want to use the pin 0 as output. It is configured as below
NRF_GPIO->PIN_CNF[0] = (GPIO_PIN_CNF_SENSE_Disabled << GPIO_PIN_CNF_SENSE_Pos...
Hi,
I using nRF51822, S110 and NUS to send the data to the phone.
When sending the data, I using ble_nus_string_send function.
I need the execute time to the phone...
When scanning for peripherals using the Master Control Panel Android app, most of the various BLE devices scattered around me show up with a "connect" button next to them...
I have a development board with the AC variant, but for my custom board I have an AB. I am able to flash code using Keil to the development board, but when I change the device...
Can anyone suggest an I2C LCD driver for use with the nrF51822? We will likely be driving a 96-segment LCD but a dot matrix LCD may be an option.
The application is for...
I get the following error on doing OTA DFU using an Iphone with IOS V8.4.
Created .zip files using nrf.exe
Commands used
nrf dfu genpkg --application...
Hi everyone,
We're working with nFR8002 devices, and it works fine most of the time.
Even after losing the link intentionnally (Bluetooth stopped, or walking out of Bluetooth...
This question devzone.nordicsemi.com/.../ appears to show that S132 expects the FPU to be available and activated.
Does the S132 really need/use the FPU or is this an artefact...
Hi,
I know that when advertising in non-connectable mode, the fastest advertising interval is 100ms. I have some questions about this:
Is there any document explaining...
I have been using NRF51822 for some time as BLE chip with services.
For some debugging reasons I need a faster stream method...
I looked at Gazell and found it simple to...
Hi, I have a question about this memory layout .
At Figure 2 (of the memory layout), it erases the previous application.
After that, at step 1, it says that the firmware...
Hello,
i have a BLE device running with a service with three writable characteristics. At the moment I have one data handler function.
If there is any characteristic written...
