Hello,
I would like to develop a custom key sharing algorithm for nRF8001 chips. As far as I have understood the only way to use full 128-bit temporary key (TK) is OOB...
i am useing nRF51822 pairing with nRF24lu1 over GZLL protocol now,
is there someone have the experience on how to config the parameter of GZP_TX_RX_TRANS_DELAY in function...
I have a peripheral running the S110 stack, which presents a characteristic to which I want the central (running S120) to be able to do a long write. What I've been trying...
Hi all,
I have been trying to combine the UART and hID Keyboard examples into a single application.
I want to use the HID part to send specific keystrokes using buttons...
Hi, I'm new to BLE and just started feasibility testing, using RF8001, on a small device with no IO. The device will have a unique code set at factory, and printed on label...
I had the same experience as fishman and I went back to give Eclipse a try. (Post: nRF Beacon does not build on Android studio) I tried to build it in Eclipse Luna with the...
I would like to store some configuration data on non-volatile memory in nrf51822.
I'm using pstorage library to access flash, but I have problem with api calls. What I am...
Hi,
I'm developing custom PCB with nrf51822 (low voltage mode) and I have troubles with flashing the chip. I cannot see the chip in nRFgo Studio. I can flash original devboards...
Dear SOC developpers,
As many kickstarters i bought an RFDUINO kit, then I made a cool prototype thanks to the easy Arduino compatibility. I'm now thinking of industrializing...
Is there a simple software code example how to configure an interrupt handler for a single GPIO-pin? I am using nRF51822 chip with softdevice S110 and the interrupt source...
My question a little weird. Because I am super beginner about BLE. So what I want is how to write string data. now i am looking to information about this. I cannot find it...
Hi
I'm trying to implement bonding in a device based on the S120. As counter part i've used a S110 device or an iOS device (realized with LightBlue App).
While searching...
Hi All,
I am using nRF51422 and now doing ANT+ certification test with tool v1.3.6. And i find out some problem with the received value on my display in case of following...
Hi
i am not able write my application after I flashed the SD. I am using Jlinker lite (the one that comes with the Dev kit) and the scripts from the nrf pure gcc . I modified...
Hi everyone,
Is it possible to connect 2 devices simultaneously with the nRF51822 device? As soon i connect one device, the advertisement stops.
So, for me it would be...
I've already posted my problem here. But it seems a dead thread.
devzone.nordicsemi.com/.../nrf51822-timer-problems
I ran into trouble when using the app_scheduler without...
Hi, I've been trying to use the timers on nRF51822 but I just can't get them to work in my code. When debugging (with GDB and Eclipse), the execution always stops with the...
Hello.
I've asked a question a while ago, devzone.nordicsemi.com/.../sd_flash_page_erase-failing-with-s120
I've been using Linux, jlinkexe, and gcc that time. Now I...
I just got the new Nordic "mbed" dev board and have started experimenting with it.
In another thread it is explained that the softdevice is bundled into the generated ...
