Hello：
Why Bluetooth Go to system-off mode, sd_power_ramon_set can not be stored. In D: \ RAM save nrf51_sdk_v5_2_0_39364 \ nrf51822 \ Board \ nrf6310 \ s110 \ ble_app_rscs...
Hi,
Recently I want to set up a dynamic network that with the node change this position ,the network will change dynamically.But there is the question,with the node's position...
Dir Sir. I am checking the current profile of nRF24AP2 in RX mode.
After "open channel" command, I found the peak current at 10ms interval until connection pass.
How does...
Hello,
I am using Nordic's UART service to communicate with my project. I use iOS and also Master Control Panel (with a dongle) on a laptop.
I have two questions:
...
SWI*_IRQ is using by softdevice to send event to application, I want to know which priority does softdevice set for them?
Does sd_nvic_critical_region_enter() disable...
I am a started guy.
I only need a bluetooth device (BLE) to check the signal and mac address.
What is the best choice?
I need the smallest and low powered!
Thank you...
Hi,
My S130 based BLE implementation, when scanning, seems to receive BLE advertisements out of order, when the traffic is high. I wonder why. Could it be so that the callback...
Hi,
I would like to misuse the SDK by creating an communications systems based on advertising. From several Q&A posts, e.g. this one ), I understand that the current S130...
Hi,
I am writing an application on top of NRF51, using a S130 Softdevice. I wonder about the concurrenceness (?) of the code I write, and especially if I need to use critical...
How do I make sure, the GATT server running on the BLE peripheral client connects only to a specific app based central/GATT client app, which has been authenticated via web...
Hi everybody!
I am working on ANCS and I found a problem that: At the first time I connect my Iphone to the dev kit, the pair request appeared on the Iphone. If I ignore...
Hi,
I have been having a lot of problems communicating with an Atmel SAM D09 as a slave, and an nrf51422 as a master.
I seem to have two problems, hopefully solving...
Hi all,
I design the kb based on the SDK6.1 and SD7.1 with 51822, and doing the PTS certification now, but meet some problem on TC_CON_BV_01_C, ATT Write error, such as...
the error messages show following:
compiling system_nrf52.c...
RTE\Device\nRF52832_xxAA\system_nrf52.c(92): error: #136: struct "" has no field "A0"
RF_TEMP->A0 = NRF_FICR...
Hi guys, I use old project try to build again in Keil when I installed nRF51_SDK_8.0.0. But I get the:
.\Objects\ble_knob_detection.axf:
Error: L6200E: Symbol
GPIOTE_IRQHandler...
Hi guys,
Has anyone encountered following warning message when using nRF51 SDK v8.1.0 or 9.0.0 and compiling project by GCC arm-none-eabi (I'm on V4.9 2015q2 which is the...
Hello,
I have a peripheral that manages several bonds to known centrals. Assume I want to pair with some fresh central, yet I need to do that within physical reach of another...
Hi, This is Venkatesh. This is my first question posting here. It is great pleasure to use this product. I have installed SDK of NRF52832. but I am not getting "boards" folder...
Hi..... This is Venkatesh. I am using nRF52-DK Evaluation kit. This is my first question posting here. It is pleasure to have an account to share my knowledge and get the...
