Hi Nordic Team,
The atomic fifo implementation is based on armv7-M, right now I want to port it into cortex-A processor, I made some changes to get it compiled without...
Hi,
Kit:nrf5340
Can you please tell me if there is any example in nrf connect SDK v1.5.0 related to data transfer concepts.
Is ble controller will be enabled during...
I'm was testing the gsp sample in samples/nrf9160/gps. It runs fine on my nRF9160DK and reports NMEA messages. However, when i ran it on my custom board, it failed in setup_modem...
Hi,
I'm attempting to obtain sensor values for a project to be completed less than a week from now and I have not yet started programming so any help would be greatly appreciated...
Hi
I am using nrf52832,SDK version: SDK : RF5_SDK_17.0.2 .
USE CASE:We have two central and one peripheral.We need to control two central with one peripheral(REMOTE...
Hello,
I am facing an issue with SPI when the SoftDevice S132 is enabled and i cannot figure out what the problem is.
The following test works perfectly when SoftDevice...
Not sure if this is the correct place to ask this question.
I can't seem to find the download location for the Master Control Panel PC application. It seems to only available...
Hello,
I am currently trying to generate a PWM signal on P0.00 and am not having success. If I drive P0.00 without PWM, everything works fine. Is there anything that would...
I have 2 nRF51 Development kits and a nRF51 dongle that I am using for proof of concepts. I am mainly using the nRF51 IoT SDK because we are looking at using IPv6 with 6LoWPAN...
I'm looking at log_uart_init in the nRF5_SDK_11.0.0-2.alpha and wondering if it would make more sense to allow the application writer to pass in a baud rate.
I'm trying to program a nrf51822 custom board using the SWD interface of the nrf51 DK. The board is using the low voltage configuration.
I'm not duplicating this question...
The IoT SDK Documentation page is getting Error 404 not Found.
Here is the error:
The requested URL /nRF51_IoT_SDK/doc/iot/html/index.html was not found on this server...
I know the softdevice region in the nrf51 is determined by the CLENR0 register.
But I read that the CLENR0 register is removed from the nrf52 and the MWU can be used to achieve...
Dear Sirs,
I buyed recently a Bluefruit LE Friend based on chip nrf51822. I triyed to get working with the ble-sniffer without success.
I don't have programming interfaces...
HI,all,
MERRY CHRISTMAS!!!!
i have an issue when i want to try the data transfer using timer
i have a idea about it , but i do not know how to achieve it.
-my project...
Hi,
Just got the nRF51822 Bluetooth Smart Beacon pca20006.
I would like to download the Firmware for it, but it requires a product key.
All I have is a set of stuff...
Hi ; Following my question how-to-flash-with-jlink-command-line which was successful, I can flash Soft Device and my app on my nRF51822 board (mac os x + gcc)
Now I would...
I am trying to set the transmit power of the NRF51822 (e.g., on the PCA10000, v.2.0.0, but the same happens on other nrf51-devices). I am not using any softdevice.
I use...
Hi
I've updated our platform to using the S130 2.0.0-7 Alpha (Update1). It turned out, that the initialization in out application failed, because erasing a flash page never...
