Hi Nordic Team,
The atomic fifo implementation is based on armv7-M, right now I want to port it into cortex-A processor, I made some changes to get it compiled without...
Hi,
Kit:nrf5340
Can you please tell me if there is any example in nrf connect SDK v1.5.0 related to data transfer concepts.
Is ble controller will be enabled during...
I'm was testing the gsp sample in samples/nrf9160/gps. It runs fine on my nRF9160DK and reports NMEA messages. However, when i ran it on my custom board, it failed in setup_modem...
Hi,
I'm attempting to obtain sensor values for a project to be completed less than a week from now and I have not yet started programming so any help would be greatly appreciated...
Hi
I am using nrf52832,SDK version: SDK : RF5_SDK_17.0.2 .
USE CASE:We have two central and one peripheral.We need to control two central with one peripheral(REMOTE...
Hello,
I am facing an issue with SPI when the SoftDevice S132 is enabled and i cannot figure out what the problem is.
The following test works perfectly when SoftDevice...
Hello All,
I have modifies the Spi Master code to communicate with an ADXL345 Accelerometer. I set up my powermode and the percesion in the setup phase. However, when I send...
Hello, Nordic Team.
In my program, I have to change the value of the characteristic before start. I write:
case ACI_EVT_DEVICE_STARTED:
g_aci_state.data_credit_total...
Hello,
I want to make my Arduino coupled with the nrf8001 advertising a simple data (an integer). There should also be a possibility for dynamically changing the advertising...
I have a Jayconsystems breakout board for the nrf8002 bluetooth chip. Nothing is connected to the breakout board and the chip is unprogrammed. My current meter reads 6.0 mA...
The nRF8001 Product Spec says,
"Dynamic Window Limiting reduces the average current consumption by reducing the window widening of the receiver ... Enabling this feature...
Hello,
I am trying to play alarm in button click using nrf code. I am using Nordic nRF51822 device and trying to integrate with android device. When I am using linkloss then...
Hey guys,
Working with the simple be_app_beacon example on nRF51. I’d like to be able to stop and start advertising. But after stopping advertising, I’m unable to start...
Hi，
Can the examples in <keil_location>ARM\Pack\NordicSemiconductor\nRF_Examples\9.0.0 of PCA10028(nRF51422 chips) be use on nRF51822 chips? Or how to modify it to adapt...
Hi
in my application I use about 8 app_timer instantiations (so 8 x app_timer_create), with various frequencies.
I noticed now that one timeout handler is triggered twice...
any body know about android code for pairing with ble (nrf51dk)?
please help i want to pair my android app to the chip. app is discovering the chip but not able to connect...
Hi
nrf 52832 is able to run in 64 MHz using external 32 MHz crystal.
I wondered if I can use an external 16 MHz crystal, and get the CPU to run in 32 Mhz.
Thanks
...
Hi, All
sdk v7.2, IOS 9.1
I know after peering with IRK, iOS will connect 51822 actively.
There're some issue in my project. It's not certain happen.
At most of...
I developed an application program and I have a hex file generated from mbed compiler, and would like to know if I flash this hex file using a J-link interface on NRF51822...
