HI,
I am using the nrf_desktop sample in NCS V3.0.2, I want to buil with prj_release_dongle.conf , the setting
but build fail, I check the file Path: it should be F...
Hi:
I'm doing exercise 1 of lesson 1 of the nRF Connect SDK Intermediate course. It says: Get the source code of this course as a third-party repository within the SDK itself...
I am using the NRF Connect SDK package provided by Qorvo, and adding BLE functions to their package. I am now trying to debug my added code.
I am using Ozone as the debugger...
Hello, We are currently working on the 18031 RED cybersecurity documentation and we have to document all known exploitable vulnerabilities in the hardware and software we...
I want to verify the 4Mbps transmission mode of the nRF54L15 series through ESB samples.But the highest value measured so far is 2.34Mbps, which is much lower than 4Mbps....
Hi, nordic team
There is an issuse happened in my custom board with nrf52833,programming in ncs v2.9.0.
peripheral side is programmed base on peripheral_hid_keyboard and...
Hi all,
We are currently developing a modem application for use with a Linux host, based on a nRF9161 using nRF SDK 3.0.0 and toolcahin 3.0.1
When compiling the Serial...
Hello nordic,
Any chance that beacon project run on nrf51 dongle hardware ( silicon rev 2 and 3).
Ifi yes ,which softdevice and sdk ?
Any chance that beacon project run...
Hello
There are a lot of information, examples and questions about pairing with iOS, where iOS acts as central and nrf acts as peripheral, but there is absolutely no information...
Hello
This question is relevant to nrf51 as central iOS as peripheral pairing question.
We analyzed attached test project and have had some success: now we can do bounding...
Hello, I try to set up the 6lowpan environment on my rpi2 following This page
When I wanted to run the radvd demon, I got error: ioct1 failed for bt0: No such device. ...
Hello,
I have an arduino with a bluetooth module nrf8001 and I would like to develop an application to communicate with it and receive for example the temperature or humidity...
Where's softdevice s212 for the nrf52 preview kit? There are examples for ant, there's header file and tool includes in the SDK, but there's no hex softdevice in there (as...
Hello
I have got a working BLE application on a nRF51822 with the S120 as peripheral.
In my application I added 3 user defined services to the softdevice.
On Windows8...
Hi
Is there a automated testing function in the Master Control Panel on Windows? Or are there any plans for it? It would be great if there would be such a function.
I...
Hi,
I found that when I enable char. notification from my android client it triggers BLE_GATTS_EVT_WRITE where p_ble_evt->evt.gatts_evt.params.write.handle matches to my...
Hello.
I'm trying to implement my own RF protocol, with the help of reference manual and examples provided here I was able to come up with this: http://pastebin.com/t2nhkj2B...
Now with the twi_hw_master.c with softdevice, I enable the twi on the start of twi_master_transfer and disable it at the end of twi_master_transfer, but I found the twi can...
Hi All,
I am in need to implement the Central BLE device which can receive the Data from an iOS peripheral device over a particular custom characteristic, Can anyone please...
I'm trying to implement my own radio protocol but the section about addressing in reference manual is very unclear to me. In the "Definition of logical addresses" table it...
