Hi,
I am using a custom pcb with a nRF51422 chip, and trying to setup ANT communication between 2 modules, but the sd_ant_channel_id_set call returns an invalid address...
Hi,
To use bidirectional continuous scanning mode in ANT, I have to transmit Extended Broadcast/Acknowledged/Burst messages using ANT Msgs 0x5D, 0x5E, and 0x5F (ANT Message...
We are preparing to get BT qualification for our product, developed with the 6 stack now, however want to update to 7 when it is finally released. A comment from the testing...
What is the best way to minimize transfer in progress errors when trying to send ANT messages? I am using the S310 stack on an nRF51422. I have a busy ANT channel that is...
I'm running into a weird timing issue with a nRF24L01+ which I'm not quite sure how to work around in the general case. The basic setup is two radios, A and B. Auto acknowledgement...
I am using mbed library to get leg up on development.
This is the first time I am writing any MCU application and it sure makes things a lot easier.
I am using nRF51822...
I've recently began experimenting with the HID service and connecting to iOS devices in order to achieve lower connection intervals with Apple products (as described in their...
Hello
I have a problem with the power of my modules nRF24L01
while awaiting the arrival of data consumption varies between 15mA and 20mA , I am feeding with 9V batteries...
Hi!
I'm using the RNG to encrypt data that I must send via SPI to another module. I'm using the function "sd_rand_application_vector_get", because I'm working with Soft...
Hello,
I'm just getting started with my nRF52832 and I am still trying to get the first example of the tutorial page running ( Getting started with nRF5 DK .
I did everything...
Hello,
I am doing a project that involves getting data from 2 PTX nodes from the slaves via ESB and sending the data obtained to my android phone via BLE. I am doing so by...
Hi,
We have created a new button events for our application in which it will record total time/ticks that the button is presses.
When you press button for 3-4 sec BLE...
Hellow,
I am trying to add different UUID bases for every characteristic.
I add the service like this:
uint32_t ble_service_init(ble_t * p, ble_write_handler_t write_handler...
I see at infocenter.nordicsemi.com/index.jsp a note how:
Missing feature: Serialization of the latest S132 SoftDevice v3.0.0 API (work in progress)
My questions...
Hi All,
It seems that my question may be repeated but I went over almost all similar posts and followed the suggested resolution, however no luck :(
I downloaded the...
Hi,
I have used a modified ble_uart example. I have added 14 extra characteristics in that example. When I have the device name to be 'devic NM' the number of attempts to...
Hi,
I would like to use nrf51822 chip with 128kB flash. My application was made based on the template version which is attached in SDK v11.0.0. Only blank template version...
I'm using the nRF52. I started off with SDK11.0.0 and noticed that SDK12.0.0 is available. It seems that the GPIOTE IRQ priority has gone from 2 to 6. Any reason for this...
Not a question, reporting a typo. InfoCenter "nRF52832.Product Specification.RADIO.Packet configuration" about the sixth paragraph "The S0INCL field in PCNF0 determines if...
Hello,
When I use the .hex of the tutorial, works ok. But when I compile the tutorial works Ok until when it suppost to sleep (after the timeout time), then gives an error...
