Hello:
Why do I erase SDK5.2 version of flash and read not, in SDK4.2 can. I tested nrf51_sdk_v5_2_0_39364\nrf51822\Board\nrf6310\flashwrite_example is a good example.However...
before i write the flash, it has been erased.so ,its value is all 0xff.
when i write 0x00 to flash address 0x0001,the value read out is not 0x00 but 0x01,and the value in...
I'm looking for a way to use the nordic uart service ( devzone.nordicsemi.com/.../ble_sdk_app_nus_eval.html) from Linux using the native Linux BLE Stack (BlueZ). My application...
Hi,
I've created an application using the S110 experimental ANCS demo. I successfully implemented ANCS and then began to structure my application around it. At some point...
Hello,
In an ongoing company project we use a couple of nRF51 transceivers forming a beacon enabled wireless sensor network consisting of one base station and multiple...
I want to count clocks in order to implement a watch. I use the RTC0 as my time-base and count mainly with this device. As it has just 24 bits it would not last for long,...
Hi,
how long does it take time if i would wake up a nrf51422 rev2 (ANT and BLE) in deepest possible sleep mode ?
And how long does it tai if after wakeup it had to communicate...
Hello everyone,
The more I learn, the more I learn how much more I have to learn.
I am pretty new to embedded systems development. I am tasked with developing an nRF52...
Hello,
I've had to redesign my bootloader and I am now stuck with a problem that I can not solve. I need to know the correct workflow for switching from bootloader to application...
I use the nrf51822QFAA, and s110 v8.0.0.
now I need update the application,i have the keil created hex file,
How can I create the ZIP file use the application hex file?...
I have built a PCB that includes the nRF51822. I have AIN7 reading an input voltage that I measure on my DMM at 269mV.
When I measure the voltage through the nRF51822's...
Hi, I have an application where I am recording button presses using a beacon-like implementation. The button presses represent start/finish events for a race and are communicated...
In my setup, i have a Node with SD130 as peripheral to Smartphone and as a central to a BLE peripheral.
I need to store some Unique ID about the Smart phone and a Peripheral...
I find out that
The s110 can only connect to a single
central, but is able to do
non-connectable advertising while in
that connection
by here
So is this...
Hello,
I have a problem with the sd_flash_write function. It HardFaults on me and I can't seem to find out why. The Addresses are 4 byte aligned...
The function is called...
Hello,
I have written a timer driver with timer 0 without SD and used 24 bit mode and it is working.
But when I used the same driver with softdevice and Timer 2 and...
I have a problem enabling TIMER1:
If the prescaler is set between 16MHz and 2 MHz the firmware fails to enable the SoftDevice, even if I didn't manage TIMER0, but TIMER1...
Hello, I have looked into the compatibility matrix and I couldn't find any clear answer about if the NRF Beacon Kit is compatible or not with the S130.
Does anyone tried...
Hi,
I'm now going to combine the proximity program with the ancs program, but I don't know how to make it.
When I try to add the proximity program to the ancs (I add tps...
Hi all,
I want to upgrade current SD from 7.0 to 8.0 by DFU, and try it as followed:
1.Use the nRF Toolbox 1.12 in Android;
2.Select 'Soft Device' as the file type...
