Hello.
Initially when reading the Gazell documentation I didn't think it'd be a problem but now in Keil seeing this has introduced some doubt whether it's a thing:
...
We would like to be able to calibrate the rRF9E5 ADC
Our proposal is to permanently fit voltage dividers, each using two precision resistors, on two of the ADC Ports and...
At some point in the past I had nrf51+gdb+breakpoints working just fine. I even have a bunch of __BKPT() calls in my various error handlers to trap into the debugger.
At...
Hi,
I'm trying to program nRF51822 Beacon Kit using nRF51DK. I'm trying to load the example ble_app_beacon to the beacon kit. After uploading SoftDevice 7.1.0, I try to...
Hello
I'm using the nRF51 DK and I have a UART over BLE link set up between the board and a phone with the nRF UART app. I'm trying to get the board to execute a particular...
Hello there guys i been reading your 100 pg PDF for awhile now and im yet to understand or realize how is it that i add/place/create a payload or data to send/Tx via Master...
I am interested in writing a BLE central that reads data from multiple BLE Nordic sensors. The BLE central will be running on Embedded Linux which uses the BlueZ stack.
...
Hello,
I have a nRF51 DK (PCA10028) and I managed to programm an onboard nRF51422 SoC. Now, I'm trying to programm a nRF51822 on a costum board (WT51822-S2). I wanna try...
nrf51822 SDK 9.0
iphone 6plus System version IOS9.2
When the phone receives the QQ message "static void notif_print(ble_ancs_c_evt_notif_t * p_notif);" can execute.
but...
I am programming with mbed, and i am trying to start the adc-task via ppi and timer cc events.
another ppi channel is used to toogle the LED.
I am using the nRF51822 on...
Hello There,
I am looking to use many of the features found in the SDK Common Library such as the application timer. I am looking at the documentation and I am unsure how...
According to the S132 v2.0.0 release notes it states:
"minimum required memory - actual requirements are dependent upon the configuration
chosen at sd_ble_enable() time...
I need to implement the micros() function of arduino on nrf51822. Can someone guide me on how it can be done?
This the function for Arduino:
unsigned long micros() ...
We have two developers running the same version of IAR and the SDK and one of them has different device options under the project options. My IAR project works with NordicSemi...
Am using SDK 8, Single or dual bank serial bootloader brick during SoftDevice upate. Brick happens only if softdevice CRC validate fails(Stop Cmd). During CRC validate pass...
I'm connecting to the same microcontroller with nRF Master control using the same firmware, but I noticed that the connectivity time is not similar with every connection....
Hi guys,
I have a question when design the pcb layout stack with nRF52832, CSP package (CHAA). As recommendation from Nordic, using 4 layers will give best performance...
I noticed that Digi-Key had a new part number for the nRF52 DK that wasn't designated "Preview", so I assumed it might be the final silicon. However, nRFgo Studio identifies...
Now I work on designing a product, which is implemented by sending LMP commands to a bluetooth device with nrf51822. Unfortunately, nrf51822 liberary could not provide the...
Hello All
I'm newbe for this device. Now my customer asking multiple offline programming IC NRF51822-QFAC-R. But I'm not sure the device can support parallel programming...
