While building the program I get this error message: "DT_N_NODELABEL_cpucell_cpuapp_ipc_shm_trace_REG_IDX_0_VAL_ADDRESSU" As far as I can tell, this error message is releated...
Hello,
I have a pin on port 1 of the nrf54l15 that I am bitbanging for a custom tx/rx 2-wire protocol. I have already managed to implement the tx capability and I was hoping...
Hi,
I've got two ESB transceivers talking to each other - a PTX on nRF52832 (E73 module) and a PRX on nRF52810 (Holyiot module, the "tag"). Both chips can obviously TX and...
Hi Nordic team,
I am currently researching Bluetooth Channel Sounding, where I have setup two nrf54LM20-DK as intiaitor and reflector respectively.
I am using NCS 3.3...
Hi:
I use sdk ncs3.3.0 and nrf54lm20dk.
Failed to return using AA dfu_target_init.
OTA firmware is zephyr.signed.bin.
I: DFU header I: 3d b8 f3 96 00 00 00 00...
Hello,
I've been asked to create a new ticket for this. It follows on from
@ Erlend Isachsen asked:
So before marking this problem as resolved, it would be nice to be...
I use the following :
-> nRF52840 Dongle / µC on the other side
->Blutooth Low Energy v3.0.1 (desctop version)
I try to read a characterictic after connecting and get...
During an execution of a winbond w25q64jv command (any command) during a BLE_GATTS_EVT_WRITE event the SPI bus goes inactive after the command is sent:
There is apparently...
Hello,
I tried to change the defined UUIDs for the BLE service and characteristics in the LED Button Service example (lbs.h).
E.g.
But the result is somehow...
Hello, I found that my device is more prone to disconnection due to 0x8. And I saw the log and found that most of the disconnected cases were immediately disconnected as soon...
I am using the NRF distance measurements examples between two nRF5340 boards to calculate the distance between them. I want to know how the distance is calculated in phase...
I am attempting to download v10.18.0 of the nRF command line tools for Linux x86 64. However, the .deb file provided is for arm64. Could you please fix this in the nRF command...
While trying to download the latest nrf-commanline-tools for LInux x86_64 I have noticed that the link for the DEB package is wrong: it leads to the arm arch., not the amd64...
Hi.
We've built an app for the nrf5340-based module using the nrf connect 1.6.1 SDK and its out-of-the-box Zephyr/MCU boot loader etc., code base. We build using west, which...
Hallo Team,
We are planning to use nrf5340 for one of our project which requires low energy audio and sensor data transfer. Can you please evaluate if our use case is...
Hi, I am currently developing on nrf9160 DK, and would like to set pins 0.14 and 0.15 as analog inputs to read data from sensors, similar to arduino uno, but not sure how...
Hi,
I developed a firmware without softdevice for a custom board with nRF52840
I recently decided to add a bootloader to my application and I based my bootloader code...
Hi all, I have worked on a Central device, whose objectives are to scan specific beacons (filter using MAC address), make broadcast and establish connection with specific...
I'm developing with a Thingy:91; here (New Zealand) we have both M1 and NB-IOT but in some locations where the product will go there's only NB-IOT so I'd like to verify the...
