i've noticed that the pc-nrfconnect-ppk is written in typescript (with a lot of .tsx files for visual elements)....
my understanding is that at the lowest-level the power...
I used the "echo_bot sample and tried to alter it to use UART2 instead of UART0. Aftet changing the code and putting in the needed overlay, the main() program begins to run...
I am using the `mcumgr` subsys to enable the DFU (Device Firmware Update) capabilities in a custom device that also features a custom (non mcuboot) bootloader. In order to...
Hi !
I have a peripheral that can connect to other nRF52's or a smart phone such as iPhone or android. Is there an easy way to detect a smart phone?
The best I can think...
Hello nordic team!
Issue:
I am reaching out because one of my nRF9151DK does not seem to have associated character device files created when I plug it into my laptop,...
I have an application that I want to build and run on 5 or 6 target devices including a nRF52840DK, nRF52840 Dongle, and custom boards. There are areas of the code that only...
Is it possible to see LOG_INF() or LOG_ERR() messages from custom board software when the custom board is connected to a nRF52840DK through connector P20? The custom board...
Recently s110_nrf51822_7.0.0 softdevice has been released. I cannot find specification where those new amazing features (they are impressive, indeed :) ) are described, so...
Theoretically, if I were to expose a GATT service to let a central write a 128 bit PIN to my characteristic, would I then be able to persist this PIN somewhere in the softdevice...
Hi,
I am developing firmware based on nRF51822 SDK for s110.
I would like to modify one or two bytes at Manufacturer Specific Data area in advertising data packet.
But...
Using nrf51822's PCA10001EK and trying the included s110 example called ibeacon. Keep hitting error 0x3001 which corresponds to "connection handle" error.
This error is...
I have not been able to make this app work. I programmed S120 as softdevice and loaded the application. Ran into problem with scatter file. I changed it based on the s120...
When sending data on a pipe with ACK (indicate), the acknowledgement seems to get lost if the device gets disconnected right after having sent that data. Is that a normal...
Hello,
I am trying to build a single device, lets say loaded with firmware "A".
I would like to have two of these devices, both with firmware "A" to detect proximity...
I can't find anything to indicate for sure that the S120 BLE softdevice will work on the nRF51422 BLE/ANT chip. I'm pitting BLE vs ANT for my current use case and being able...
nRf51422 flash data retention is 10 years at 40°C. We need for our application (motor control roller shutter) 20 years. What can you do to increase this value?
Hi All,
Please correct the following in my understanding. Also , i am planning to build a
remote controlled device using a PWM output. How does ATT,GATT and GAP affect/influence...
I recently purchased an nRF51822-mKIT and I'm having great difficulties in getting it to talk to either a Windows 7 or a Windows 8 desktop PC, or a Ubuntu linux desktop PC...
Hi.
I have just a question:
Can the same device work with gazell protocol and bluetooth LE alternatively?
I want a net with a host and some devices, but host must be...
I've somehow lost the ability to perform over the air DFU from Master Control Panel.
I have reinstalled the J-Link drivers, nrfgo studio, I've flashed the PCA10000. I can...
