Using the nRF Beacons app, but cannot see the battery condition of each beacon. Is this already implemented - if so how to turn on? If not how is it implemented?
Using the nRF Beacons app, but cannot see the battery condition of each beacon. Is this already implemented - if so how to turn on? If not how is it implemented?
Hi All
I am doing a BLE based project using nRF51822.Where i need to handle the message [with UUID] by using ble_gatts_char_handles_t.
so, can any one please share information...
I have a central application and peripheral application that are based on the multilink-central/multilink-peripheral examples.
I've modified them to run on the PCA10001...
Hi All,
I'm using nRF24L01P for TX device and want to receive packet from nRF51822 RX device.
nRF24L01P TX device Register settings are as follows;
Reg.EN_AA=0x00...
I am trying to develop for some nRF51822 mbed boards, and I would like to use the S130 SD to enable both central and peripheral behaviour. The machine I'm using for development...
I'm using the nRF51822 eval kit
I have installed MCP but after starting I get pop-up: Master Control Panel has stopped working
In nRFgo Studio / Device manager pane...
Hi,
Im trying to send data via the NUS service which is larger than 20 bytes. I understand that I have to break down the data into chunks in this case, which is what I...
I am new to embedded programming.
I use JLINKEXE (on Mac) to load the S110 softdevice and my application. When I am in the debugger, the app loads and all runs as expected...
Hi there! Running a bootloder of sdk 9.0 on nrf51822, a problem occurred in a special way. In a normal way, program softdevice and bootloader with studio respectively, then...
I will write time to my ble device and need write uint32_t via characteristic. When i try only (uint8_t)data[0] is correct.
How can I do writable characteristics (uint32_t...
Hi,
I have a peripheral device with custom Services and characteristics which is working properly (I can tell because it got tested with nrf Master Control Panel app)....
My PC completely bricked so I'm setting up Eclipse and GCC on a new Machine. Everything seems to work except I'm getting two odd compile errors on INLINE functions. The compile...
Hi,
i am using blend micro with nRF8001 .. i want to make the bluetooth module to sleep on an interrupt such that it should consume the lowest power.
thanks in advance.
I want to use Seggers RTT for data logging.. but after 199lines the Viewer starts to overwrite the old lines.. so that only the most recent 199 lines are displayed..
Are...
Hello,
I want to use nRF8001,but I'm a beginner for nRF8001,I have no idea how to start my software design.
Could anybody give me some guide about how to start my design...
Hello Everyone
i have been trying to implement the pwm library from the GITHUB inorder to make the buzzer beep sound but after compilation it is showing these two errors...
i want to add a characteristic readable that hold a device TimeCount; timeCount is increasing;
ble client (andorid) can read the characteristic at any time;
how can...
Hello,
I'm going to start a new design based on the CSP 3.0 x 3.2 package for nRF52832 (CEAA version), I already find the reference information for the QFN 6.0 x 6.0 package...
