We're looking for a Nordic nRF51822 based low profile/small USB dongle that we can use for our iBeacon software.
It would need to come complete with casing and the ability...
Hi all,
i want to establish connection between two threads in cmsis-rtos, can i use
1) semaphore to do this?
2)message queue should be used or any other ipcs can be...
Hi,
I have two CPU in our product. (STM32F2 and Nordic nrf51422).
I use serialization function to link those two CPU(refer to ble_s110_serialization sample)
But I find...
Hi,
My behavior is as follows
Turn on my device(use 51422) and advertising(2 Service and 3 Characteristic)
Turn on my cell phone(Samsung Note3),scan my device...
Hello:
I used analog IIC write MPU6050. Again after power download programs, mpu6050 can run up there ACK response. But the debug will not run. Simulation IIC because no...
Hello!
How can I communicate with my nRF24L01+ and nRF51822 at the same time. I can set up same channel, CRC-mode and I don't use ESB. But what about address? How do I set...
Hi all,
i want to know answer related to following question
1)what is use of uicr?
2)if i place some value in uicr and then change the image,then is there will be change...
Hi, I'm assuming my node will have a lot of subcribe addresses, so I try changing the value DSM_NONVIRTUAL_ADDR_MAX. When I change the value of 150, there is no error, but...
hi,
nRF6939 live cd v5.4 not download.
https://www.nordicsemi.com/Software-and-Tools/Reference-Designs/nRFready-Smart-Remote-3-for-nRF52-Series/Download#infotabs
I...
All examples included in nrf52SDK 15.2.0 when running on Fanstel USB840F which has a nrf52840 chip, using Segger Embedded Studio and one of PCA10056 or PCA10059.
Using nrf52DK...
Hi,
I want to send a 2 digit number from one avr microcontroller to another one (to be specific from atmega16 to another atmega16 avr) using nrf24l01+ .
What I have here...
Hi, we are trying to work with nRF52840. We have a problem that our hardware goes into continuous reboot mode when we disconnect the JLINK debugger. The disconnect can be...
Hi，
I'm doing a rssi detect test based on nordic mesh sdk 2.2, it runs well when connect to a computer running SES by j-link, but almost don't work when running on board...
Greetings
Newbie question:
Im new to this BLE and RF world, and i'm trying to read all the info i can before buy the nRF52 DK when it got the IC without all the "erratas...
Hallo
Im using the example of nRF5_SDK_12.3.0_02\nRF5_SDK_12.3.0_d7731ad\examples\peripheral\uart
to setup a uart that includes rx as well as tx,
I am running the...
Hello everyone, I'm new with Nordic devices.
Actually wanted to get services correspondant to I2C slave addresses and registers.
I was thinking about using the SDK template...
i am using nrf52832 in sdk11. I am interfacing motion sensor and spi flash memory. Both motion sensor and spi flash shares spi lines and having different chip select pin....
Hello
I'm implementing light switch demo code, but while build client and server code getting error
Building ‘light_switch_client_nrf52840_xxAA_s140_6.1.0’ from solution...
