Hello,
I have tried twice to request for SUPL license for getting A-GPS working but it has been denied both of the times. I think first time it got denied due to mismatch...
Hi Nordic Team,
The atomic fifo implementation is based on armv7-M, right now I want to port it into cortex-A processor, I made some changes to get it compiled without...
Hi,
Kit:nrf5340
Can you please tell me if there is any example in nrf connect SDK v1.5.0 related to data transfer concepts.
Is ble controller will be enabled during...
I'm was testing the gsp sample in samples/nrf9160/gps. It runs fine on my nRF9160DK and reports NMEA messages. However, when i ran it on my custom board, it failed in setup_modem...
Hi,
I'm attempting to obtain sensor values for a project to be completed less than a week from now and I have not yet started programming so any help would be greatly appreciated...
Hi
I am using nrf52832,SDK version: SDK : RF5_SDK_17.0.2 .
USE CASE:We have two central and one peripheral.We need to control two central with one peripheral(REMOTE...
Hi,
nRF51822. I'd like to detect single-click, double-click, triple-click, etc. button press sequences. Multiple clicks are when the next button press is within 1/2second...
we are using latest repository, did " west update" to pull the source code. Followed nrf connect application "getting started assistant" to setup the environment.
All the...
In 15.3, there is a new application type valid for DFU, external app. When loaded through DFU, the program just sits there in bank1, and doesn't get sent anywhere. I'd like...
Hi, I'm trying to use the iOS nRF Mesh Library on GitHub: https://github.com/NordicSemiconductor/IOS-nRF-Mesh-Library
I've managed to install the iOS app, but I am unsure...
Hello,
I'm attempting to connect the nRF9160 DK to our AWS IoT account. I've been following the information in this question: https://devzone.nordicsemi.com/f/nordic-q-a...
Hi, looking for some advice regarding hardfault analysis. Using NRF52840 with SDK 15.3 and SD 6.1.0, i am seeing occasional hard fault (after ~30 min to 2 hours), during relatively...
Hi,
I know it is a silly question but I would like to ask does nRF52810 support SPI, TWI, UARTE etc.
Below is block diagram from datasheet of nRF52810 which shows it has...
Hello,
I was able to flash demo .hex to my nRF52840DKs from this ( https://github.com/NordicPlayground/nrf52-ble-multi-link-multi-role ) project, but now I would like to...
I alway used direct UART command with nRF24AP2 and CW test was not a problem.
Now with nRF52xxx and S212 softdevice I try this ... but nothing works .
sd_ant_stack_reset...
I've used Segger Embedded Studio to compile and run a number of example projects -- nicely done!
Now I'm ready to start creating my own projects, with the ultimate goal...
hello,
i'm trying to communicate between a central device and a peripheral.so if multiple peripherals are present and all of their mac id is known.how can i select a particular...
SDK 14.2
i just added peer manager to an existing project, and peer manager seems to be working correctly. pm_peer_data_app_data_store() is successfully called to save addition...
