Hello,
I have tried twice to request for SUPL license for getting A-GPS working but it has been denied both of the times. I think first time it got denied due to mismatch...
Hi Nordic Team,
The atomic fifo implementation is based on armv7-M, right now I want to port it into cortex-A processor, I made some changes to get it compiled without...
Hi,
Kit:nrf5340
Can you please tell me if there is any example in nrf connect SDK v1.5.0 related to data transfer concepts.
Is ble controller will be enabled during...
I'm was testing the gsp sample in samples/nrf9160/gps. It runs fine on my nRF9160DK and reports NMEA messages. However, when i ran it on my custom board, it failed in setup_modem...
Hi,
I'm attempting to obtain sensor values for a project to be completed less than a week from now and I have not yet started programming so any help would be greatly appreciated...
Greetings,
I was following the nRF52840 Dongle documentation ( https://infocenter.nordicsemi.com/index.jsp?topic=%2Fcom.nordic.infocenter.nrf52%2Fdita%2Fnrf52%2Fdevelopment...
I am using IAR 7.40.3.8938, i was looking through the include directories in IAR and i noticed "nRF52_SDK_0.9.0_0c82e3e\components\toolchain\gcc". I removed it and i got the...
Hi,
I want to see if a button is pressed. But the function app_button_is_pushed() is not working corectly. I am using the s132 in the ble_app_blinky peripheral example....
Hi,
I try to read analog voltage over P28. Digital value(result variable in the code) always 238 as decimal.
What is the missed thing in the code?
Voltages supplied...
Hello,
I am using nrf51422 with stm32L0. There is a uart connection between nrf51422 and stm32l0. I want to transfer data from stm32l0 to nrf51422 through usart and push...
Hi,
I'm using nRF52840 with two UARTs on SDK15.2.
I made some changes from the post below
https://devzone.nordicsemi.com/f/nordic-q-a/25173/nrf52840-uart1-not-working...
I want to turn an LED on when the Counter in a Timer peripheral is equal to 10.
I tried reading from EVENTS_COMPARE[0] (TIMER0 -> EVENTS_COMPARE[0]) in the if argument...
I am working on a capacitive sensing application using the SAADC module and csense code on the nRF52 DK (SDK v14.2). I use the recommended hardware configuration, with a charging...
On SDK 15.x.0 only
Please Do not judge the quality of SDK based on number of entries here. This thread should be considered as part of Nordic effort to find issues and possibly...
Hi. In the nRF52840 SDK example USBD_CDC, the APP_USBD_CDC_ACM_USER_EVT_RX_DONE event only seems to fire every other byte that is sent through. E.g. If i send one character...
