Hi Team,
To implement iBeacon what are the things to be take care at the peripheral side.
Whether the code for advertising the peripheral in "CoreBluetooth" and "CoreLocation...
Hi, I have both the nRF8001 dev kit and the nRF51822 Eval Kit (EK). We are using the nRF8001 for most of our project with the BLE Arduino SDK. But I wanted to just load a...
Hi,
What is the suggested method to change a pending request, and make it earlier than previously requested, without closing and reopening the session?
For example,...
Hi,
I am using a custom pcb with a nRF51422 chip, and trying to setup ANT communication between 2 modules, but the sd_ant_channel_id_set call returns an invalid address...
Hi,
To use bidirectional continuous scanning mode in ANT, I have to transmit Extended Broadcast/Acknowledged/Burst messages using ANT Msgs 0x5D, 0x5E, and 0x5F (ANT Message...
We are preparing to get BT qualification for our product, developed with the 6 stack now, however want to update to 7 when it is finally released. A comment from the testing...
What is the best way to minimize transfer in progress errors when trying to send ANT messages? I am using the S310 stack on an nRF51422. I have a busy ANT channel that is...
Our hardware designed with nRF52840 and npm1300 works perfectly.
We are working on an architecture where a single central communicates with four peripherals...
Hi,
I'm trying to use the periodic sync sample app using 2 nrf52833DK (one for advertising and one for receiving sync) and been getting this assert message every time a...
We use nRF52832 to develop our sensor.
Then SDK version we used is 14.2.0, and the softdevice is S332(ANT_s332_nrf52_2.0.1)
Now we develop the FW hex file with softdevice...
Hi,
When using the NFC record example, bringing an Android phone close to the NFC tag automatically pops up and displays the text content, but an iOS phone does not automatically...
Hi I am currently using NORA-B106 based on nrf5340 to work on ble multilink things. For right now I can do multiple connections by adding several scanning filters. But I cannot...
Hi All,
I'm trying to fully disable all location services with the asset tracker in v2.6.1 while using lwm2m (so I have the lwm2m overlay enabled in the build settings)...
Hi,
I'm stuck in the Cellular IoT Fundamentals course on lesson 2, exercise 2. When adding build configuration I get the following error:
[31/167] Building C object secure_fw...
I would like to integrate the PPK into an automated test system. Are Python drivers available to query the PPK directly for current readings, power control, etc.
I'm trying to test minimum timing and performance using peripheral and central ISO under Zephyr.
I'm trying to play with the interval and latency values under the central...
When I try to debug a programm (build with "optimize for debugging" and debugging started by pressing "Debug" in VSCode) I get to the debug-view and can also go one or a few...
We are working on a custom board (gateway BIS) with the nrf5340. Currently our system is on the 2.5.2 SDK and we currently have FOTA working with an external QSPI flash and...
psa/client.h describes and defines PSA_MAX_IOVEC as follows: Just to be sure: This means that psa_call can only pass 4 input- and output vectors in a psa_call(), or? (E.g...
In the application I try to run the non-secure world mainly just calls functions/services in a custom partition in the secure world, which has more own code and also extensively...
We have started using nPM1300, but now we are unsure how to proceed.
Through our inquiries, we have learned that development requires the use of the ncs platform. However...
