Hi, I have both the nRF8001 dev kit and the nRF51822 Eval Kit (EK). We are using the nRF8001 for most of our project with the BLE Arduino SDK. But I wanted to just load a...
Hi,
What is the suggested method to change a pending request, and make it earlier than previously requested, without closing and reopening the session?
For example,...
Hi,
I am using a custom pcb with a nRF51422 chip, and trying to setup ANT communication between 2 modules, but the sd_ant_channel_id_set call returns an invalid address...
Hi,
To use bidirectional continuous scanning mode in ANT, I have to transmit Extended Broadcast/Acknowledged/Burst messages using ANT Msgs 0x5D, 0x5E, and 0x5F (ANT Message...
We are preparing to get BT qualification for our product, developed with the 6 stack now, however want to update to 7 when it is finally released. A comment from the testing...
What is the best way to minimize transfer in progress errors when trying to send ANT messages? I am using the S310 stack on an nRF51422. I have a busy ANT channel that is...
I'm running into a weird timing issue with a nRF24L01+ which I'm not quite sure how to work around in the general case. The basic setup is two radios, A and B. Auto acknowledgement...
Hi!
I am working on creating a Low Power mesh network and am trying to decide which communication protocol I should use with the NRF52840. There are no nodes in the network...
Hello,
I'm using NCS 2.0.1 on a nRF5340 board.
Currently I have some troubles with getting a response if I try to write a BLE characteristic from an iOS app. The write...
Hello, I am trying to disable using uart for console use Kconfig.
I am using sdk v2.0.2 (VSCode + nrf connect extension)
It works and the software works as expected. After...
Hi,
I would like to know how I can get the connection parameter in nrf connect for desktop. I want to assign the same parameter for our pc-ble-driver-py program.
Good day to all
I am at the final stages of developing a program for collecting sensor information from a UART and publishing it onto a mqtt server. Currently the device...
Hi All,
I am using nRF5_SDK_17.1.0
while building SDK example project uder the below path with SES
..\nRF5_SDK_17.1.0_ddde560\examples\dfu\secure_bootloader\pca10100_s140_ble...
Hey!
Would it be possible to use I2C and SPI simultaneously on the nRF5340? I'm using I2C/TWI for sensor data (optical based) and SPI for a DAC - need both of them operating...
Hello,
I'm doing a few power consumption tests on the nrf9160 DK with NB-IoT for a battery powered application. PSM mode works as expected but I measured a current drain...
Hello, I am looking to cheaply flash a nrf5340. This will most likely be a one-time thing, so I don't want to invest in a J-Link device.
I have an ST-LINK clone though and...
Hello Everyone,
I need help in the integration of MPU6050 with nRF52840. I know inside SDK one example is present but it worked with nRF52832DK. when I tried to build it...
Hi!
I am attempting to configure a nrf5340 dk as a central to receive BLE notifications. The code is based on the central_hr sample.
The notifications i am attempting...
I'm like 99% certain this isn't possible but has anyone tried running VS Code Server with the nRF Connect SDK?
https://code.visualstudio.com/docs/remote/vscode-server Compiling...
