Hi,
What is the suggested method to change a pending request, and make it earlier than previously requested, without closing and reopening the session?
For example,...
Hi,
I am using a custom pcb with a nRF51422 chip, and trying to setup ANT communication between 2 modules, but the sd_ant_channel_id_set call returns an invalid address...
Hi,
To use bidirectional continuous scanning mode in ANT, I have to transmit Extended Broadcast/Acknowledged/Burst messages using ANT Msgs 0x5D, 0x5E, and 0x5F (ANT Message...
We are preparing to get BT qualification for our product, developed with the 6 stack now, however want to update to 7 when it is finally released. A comment from the testing...
What is the best way to minimize transfer in progress errors when trying to send ANT messages? I am using the S310 stack on an nRF51422. I have a busy ANT channel that is...
I'm running into a weird timing issue with a nRF24L01+ which I'm not quite sure how to work around in the general case. The basic setup is two radios, A and B. Auto acknowledgement...
I am using mbed library to get leg up on development.
This is the first time I am writing any MCU application and it sure makes things a lot easier.
I am using nRF51822...
Hello
I got error in getting the mac address with available answer( devzone.nordicsemi.com/.../how-to-get-mac-address-using-nrf5340_dk) in forum. I tried to paste that code...
Hello,
I got saadc example on my nrf5340 dk running and now I would like to plot the incoming serial data.
saadc code example: saadc.zip
changed the way I got adviced...
Hello
I use the sample project for alarm (zephyr/samples/drivers/counter/alarm). I was able to build the sample and run it on NRF52DK (PCA10040) with NRF52832.
I tried...
Hi,
I am using window 10
I am trying to connect to the nRF52 DK, but it does not show me the files on the board as it is explained in the how to connect to the DK.
Also...
I have successfully built my project in VS-code for the Thingy:53. Because I don't Have a debug probe I cannot flash the firmware from VS-CODE. What are the files that need...
I was using Power Profiler app with PPK2 for capturing data on long period(48 hours) after 2 hours of running the app is crashed.
Detailed Error message
System Report...
So I am using an nRF5340DK with the "central-bas" example project. I added the MCUBoot-Bootloader by adding "CONFIG_BOOTLOADER_MCUBOOT=y" to the prj.conf file and it works...
I am implementing a port for nRF52832 for our custom communication stack. Devices are time-synchronized, radio operates in destined time slots. During the radio inactivity...
Hi all,
I am using NRF5340 with nRF Connect SDK v1.9.1. And I want to add my own .h and .lib(GCC) file into my project.
Please tell me how to do.
Thanks a lot!
Target nRF52832(nrf52dk_nrf52832) SDK NCS v2.0.0 My project base: \nrf\samples\bluetooth\peripheral_hids_keyboard
Hello. I want to increase Tx power for test. I already...
Hi.
On my production line, the first station is an automatic flashing machine, it takes the components from the reel one by one, connect, flash my program and pack again...
Hi Everyone,
I am currently developing a BLE application.
I have noticed that advertisement events do not cause the CPU to return from sd_app_evt_wait(), is this the...
Hello All,
I have a problem about conflict between Active Scanning and Advertising when I build my project from sample central_uart & peripheral_uart .
I want my nrf5340...
