Hi, I have both the nRF8001 dev kit and the nRF51822 Eval Kit (EK). We are using the nRF8001 for most of our project with the BLE Arduino SDK. But I wanted to just load a...
Hi,
What is the suggested method to change a pending request, and make it earlier than previously requested, without closing and reopening the session?
For example,...
Hi,
I am using a custom pcb with a nRF51422 chip, and trying to setup ANT communication between 2 modules, but the sd_ant_channel_id_set call returns an invalid address...
Hi,
To use bidirectional continuous scanning mode in ANT, I have to transmit Extended Broadcast/Acknowledged/Burst messages using ANT Msgs 0x5D, 0x5E, and 0x5F (ANT Message...
We are preparing to get BT qualification for our product, developed with the 6 stack now, however want to update to 7 when it is finally released. A comment from the testing...
What is the best way to minimize transfer in progress errors when trying to send ANT messages? I am using the S310 stack on an nRF51422. I have a busy ANT channel that is...
I'm running into a weird timing issue with a nRF24L01+ which I'm not quite sure how to work around in the general case. The basic setup is two radios, A and B. Auto acknowledgement...
I am currently building a dynamic multiprotocol application (Thread+Bluetooth LE) with the nRF Connect SDK. For tweaking coexistence I would like to limit the length (=duration...
Hi,
In nwp-036 page 7,here is the AOD sketch map as below :
As fat as I am concerned, the Transmitter and Receiver should be reverse ?
Or there is something I misinterpreting...
Hi,
Background: I am looking at interfacing nRF21540 (FEM) with nRF52833 (Host) - hoping there's Zephyr support available for this(?)
Question: Product spec for nRF21540...
I'm trying to find the address of an attached twi sensor by using the twi_scanner. It worked on the default pins
but when I change the pins like this
It simply doesn...
Dear Nordic team.
We have to add new sensors using I2C protocol on our previous project.
Can i configure WDIO and SWDCLK pin to I2C pin?
If possible, i will reuse my...
Hi,
I would use the test nRF9160DK and Thing91DK with CMW500 equipment under NB-IOT stanadard.
Both DK kit and Thing91DK can connected to service provider when I plug...
I am working on programming process for custom board using NRF52. I managed to create a merged hex file containing the softdevice, bootloader, app and settings files. I verified...
Hi,
I am using the sdk 17.0.2 and s112.
The Apple Watch can not connect the s112 projects ble, such as 10040e s112 and 10040 s112, But can connect the 10040 s132 ble...
I'm new to nordic development, is there any empty template when start developing
that enables ble and twi that just works?
I tried many examples and they all work but...
Hello, I came across this twitter clip by Marjeris showing a Thingy 52 relaying temp info to Alexa. How was this done? by mqtt? or as gadget? thank-you,
I'm trying to port some code from FreeRTOS to Zephyr using a Nordic nRF52840. (I've used FreeRTOS for quite a while, but am a novice with Zephyr.)
I'm using k_poll() (in...
On nRF5340, I need to generate a 5MHz &10 MHz & 20MHz, or 8MHz&16MHz & 32MHz to output for external use, how to do it?
A external sensor needs a continuous 5/10/20 MHz...
