Hi,
Recently I want to set up a dynamic network that with the node change this position ,the network will change dynamically.But there is the question,with the node's position...
Dir Sir. I am checking the current profile of nRF24AP2 in RX mode.
After "open channel" command, I found the peak current at 10ms interval until connection pass.
How does...
Hello,
I am using Nordic's UART service to communicate with my project. I use iOS and also Master Control Panel (with a dongle) on a laptop.
I have two questions:
...
SWI*_IRQ is using by softdevice to send event to application, I want to know which priority does softdevice set for them?
Does sd_nvic_critical_region_enter() disable...
I am a started guy.
I only need a bluetooth device (BLE) to check the signal and mac address.
What is the best choice?
I need the smallest and low powered!
Thank you...
I am working on code to setup a bond manager for ancs based off of the example, but have a fixed advertising and connection interval of 25ms. How does the bond manager and...
Hello,
I got saadc example on my nrf5340 dk running and now I would like to plot the incoming serial data.
saadc code example: saadc.zip
changed the way I got adviced...
Hello
I use the sample project for alarm (zephyr/samples/drivers/counter/alarm). I was able to build the sample and run it on NRF52DK (PCA10040) with NRF52832.
I tried...
Hi,
I am using window 10
I am trying to connect to the nRF52 DK, but it does not show me the files on the board as it is explained in the how to connect to the DK.
Also...
I have successfully built my project in VS-code for the Thingy:53. Because I don't Have a debug probe I cannot flash the firmware from VS-CODE. What are the files that need...
I was using Power Profiler app with PPK2 for capturing data on long period(48 hours) after 2 hours of running the app is crashed.
Detailed Error message
System Report...
So I am using an nRF5340DK with the "central-bas" example project. I added the MCUBoot-Bootloader by adding "CONFIG_BOOTLOADER_MCUBOOT=y" to the prj.conf file and it works...
I am implementing a port for nRF52832 for our custom communication stack. Devices are time-synchronized, radio operates in destined time slots. During the radio inactivity...
Hi all,
I am using NRF5340 with nRF Connect SDK v1.9.1. And I want to add my own .h and .lib(GCC) file into my project.
Please tell me how to do.
Thanks a lot!
Target nRF52832(nrf52dk_nrf52832) SDK NCS v2.0.0 My project base: \nrf\samples\bluetooth\peripheral_hids_keyboard
Hello. I want to increase Tx power for test. I already...
Hi.
On my production line, the first station is an automatic flashing machine, it takes the components from the reel one by one, connect, flash my program and pack again...
Hi Everyone,
I am currently developing a BLE application.
I have noticed that advertisement events do not cause the CPU to return from sd_app_evt_wait(), is this the...
Hello All,
I have a problem about conflict between Active Scanning and Advertising when I build my project from sample central_uart & peripheral_uart .
I want my nrf5340...
Please tell me about "nRF Util".
The following is an excerpt from "nRF Util User Guide v6.1.0
Is it correct that the maximum value of "--application-version" is 0xFFFFFFFFFF...
