Hi,
Recently I want to set up a dynamic network that with the node change this position ,the network will change dynamically.But there is the question,with the node's position...
Dir Sir. I am checking the current profile of nRF24AP2 in RX mode.
After "open channel" command, I found the peak current at 10ms interval until connection pass.
How does...
Hello,
I am using Nordic's UART service to communicate with my project. I use iOS and also Master Control Panel (with a dongle) on a laptop.
I have two questions:
...
SWI*_IRQ is using by softdevice to send event to application, I want to know which priority does softdevice set for them?
Does sd_nvic_critical_region_enter() disable...
I am a started guy.
I only need a bluetooth device (BLE) to check the signal and mac address.
What is the best choice?
I need the smallest and low powered!
Thank you...
I am working on code to setup a bond manager for ancs based off of the example, but have a fixed advertising and connection interval of 25ms. How does the bond manager and...
Using: NRF52832, SD 132 6.1.1, SDK 15.3.0, Mesh SDK 3.1.0.
Hi, I included mesh_opt_core.h in a C++ file, and got compiler errors at NRF_MESH_STATIC_ASSERT().
I fixed...
Did current OTA only can dmostrate "ble_app_hrs" and "ble_app_rscs"? Other SDK5.0.0 examples?
I want to try ble HID keyboard. So, deliver the hex file to celluar phone and...
I want to use TWI to read the sensor data. When using the software TWI, I found that the communication takes a long time, which will greatly increase the battery consumption...
I'm looking through the NRFX library and specifically the CONFIG_BSD_LIBRARY_TRACE_ENABLED feature and would like to know if it would be possible to redirect the trace output...
Hi,
I am considering zigbee on nrf52840.
I cannot find power control part (in ble power_manage function) in zigbee examples.
1. Is there not power control function...
Hi,
I would like to send multiple peripherals with each packet of bytes(244) to a central. I am using the blinky example from \nRF5_SDK_15.3.0_59ac345\examples\ble_peripheral...
Hi,
In the documentation nRF52832_v1.4, in 18.6.1 on page 82, it is indicated "A step increase in supply voltage of 300 mV or more, with rise time of 300 ms or less, within...
Hello Nordic Team, We are using nRF52840 ble chip with S140 nordic stack and SDK 15.2.0 on the SEGGER IDE installed on the Windows OS. We want nRF52840 chip to detect surrounding...
Hello,
Would like to understand more on Adaptive Frequency Hopping(AFH) behavior. We understand that AFH comes into play when lower layers detect noisy channels, blacklists...
I have just started developing with Nordic NRF52832 using the IAR Embedded Workbench. I am attempting to work with the existing Example projects provided within the NRF5 SDK...
Hi
I am using nrf52 thingy hardware version 1.0.1
I want to use OTA for the same module with customize application.
Till the time I am able to transfer firmware file...
Hello there
I'm developing a custom board for the nrf52810 and I need my product to be as small as possible. The dimensions of the reference design are just what I need...
Hi all,
I am using nRF52832 with SDK 13.0.0. And I use the ble_perpheral -> ble_app_uart example.
I am trying to send data through BLE and. I'm using timer 2 to sampling...
