Using S120 V 8.0.0.3 alpha, processing a BLE_GATTC_EVT_READ_RSP,
received 0x16 bytes of data but there is more to read. Next call to
sd_ble_gattc_read using the same connection...
Hello：
Why Bluetooth Go to system-off mode, sd_power_ramon_set can not be stored. In D: \ RAM save nrf51_sdk_v5_2_0_39364 \ nrf51822 \ Board \ nrf6310 \ s110 \ ble_app_rscs...
Hi,
Recently I want to set up a dynamic network that with the node change this position ,the network will change dynamically.But there is the question,with the node's position...
Dir Sir. I am checking the current profile of nRF24AP2 in RX mode.
After "open channel" command, I found the peak current at 10ms interval until connection pass.
How does...
Hello,
I am using Nordic's UART service to communicate with my project. I use iOS and also Master Control Panel (with a dongle) on a laptop.
I have two questions:
...
SWI*_IRQ is using by softdevice to send event to application, I want to know which priority does softdevice set for them?
Does sd_nvic_critical_region_enter() disable...
I am a started guy.
I only need a bluetooth device (BLE) to check the signal and mac address.
What is the best choice?
I need the smallest and low powered!
Thank you...
Hi there,
On my custom hardware, I am running out of I/O pins and I want to leave the SPI slave active like if csn_pin were enabled/connected to an SPI master, is it possible...
We are working on a device that communicates with the mobile device. There is a button in the device to wakeup. But this button does not wake up the device. On debugging we...
Hi I want to connect the system with random passkey, i modified the code like below the central is giving the passkey and i entering the passkey at device but not able to...
Hi,
first of all: Thank you very much for providing such a great tools as the nRF Connect Desktop tool!
I've installed the tool today and discovered, that the nRF Connect...
I'm trying to update firmware of nRF9160 DK, but fails.
I downloaded nRF9160 Modem Firmware and Modem DFU Tool from this page; https://www.nordicsemi.com/Products/Low-power...
DFU has worked fine until just recently.
Our custom hardware is using the nRF51822 and softdevice 8. We are using non-secure DFU.
We are using the latest nrFConnect. We...
Hi,
I'm trying to flash my device. Until yesterday, this command ran just fine and I was able to flashing my nRF51 chip. But I'm unable to do so anymore and can't figure...
Hello everyone,
I write this post because I haven't been able to find a solution to a problem I'm having to implement a parallel to serial converter. I am employing the...
Hi,
I am using the NRF52840, softdevice: s140, example: ble_app_uart from nRF5_SDK_15.2.0_9412b96.
short description of my application: i am developing an application...
Hi there,
I have been testing with the nrf9160 DK for a while now and I cant figure out how to get the device to sleep properly. I have been working with the asset_tracker...
Hi,
I've installed nRF sniffer version 2-0-0-beta on nRF52832 DK and verified it with BLE Beacon example. It works nice.
But when running light-switch example from Mesh...
Hi Nordic Team
We are working on BLE Modules which includes the chip-set nRF51822 and nRF52832.
We have tight form-factor and want to have longer range communication so...
