Hello：
Why Bluetooth Go to system-off mode, sd_power_ramon_set can not be stored. In D: \ RAM save nrf51_sdk_v5_2_0_39364 \ nrf51822 \ Board \ nrf6310 \ s110 \ ble_app_rscs...
Hi,
Recently I want to set up a dynamic network that with the node change this position ,the network will change dynamically.But there is the question,with the node's position...
Dir Sir. I am checking the current profile of nRF24AP2 in RX mode.
After "open channel" command, I found the peak current at 10ms interval until connection pass.
How does...
Hello,
I am using Nordic's UART service to communicate with my project. I use iOS and also Master Control Panel (with a dongle) on a laptop.
I have two questions:
...
SWI*_IRQ is using by softdevice to send event to application, I want to know which priority does softdevice set for them?
Does sd_nvic_critical_region_enter() disable...
I am a started guy.
I only need a bluetooth device (BLE) to check the signal and mac address.
What is the best choice?
I need the smallest and low powered!
Thank you...
It seems the whole system turns down occasionally after start a GATTS link connection with mobile App for a 51822 module when beacon. But the voltages of the module is OK...
Hey All,
I'm curious, has anyone integrated the csense library or lower level driver into a device they've shipped? I'm quite worried about variation and also difference...
Hello I am using nRF52832, sdk v14.1, pca10040.
With regard to SPI, I am using the spi master in nrf_drv_spi.c to handle multi-byte spi transactions. I am able to do this...
Hello,
I developed a program for nRF51-DK with mBed. The program uses the S130 V1.0.0 SoftDevice and it works great, when compiled with mBed. Recently I tried to export...
Hello!
I'm in the middle of a power consumption reduction process and have found something annoying. On the PCB (DWM1001-DEV) nRF52832 is wired to DW1000 with SPI. Additionally...
Hello,
I have cloned the asset_tracker project and would like to add the Zephyr Shell to it. There are no clear directions on how to do this. Can you point me to instructions...
Hello nRF world,
We have custom peripheral board based on the nRF51822 and need to be able to pair it with a host. Does anyone have a well documented example of code for...
Hello Nordic ,
Do i need to implement the config_ client model so that the node can be named as a client and a provisionner in same time ???
however in the example of...
I am using SDK 15.2 with IAR's EWARM 8.30.1 and the nRF52840 Development Kit. My eventual target is the nRF52-Dongle. If it matters my development OS is Windows 7 64-bit....
I would like to write code to disconnect from any connected device. My system is a ble peripheral with s132 6.0.0.
My code calls:
result=sd_ble_gap_disconnect(BLE_CONN_HANDLE_ALL...
I starting working with examples for the nRF9160. Zyphr seems like a very complicated OS (like Linux with device trees, etc) and difficult to use with a debugger.
Is the...
Hi,
I trying to convert a stm32 function code to nRF52. The goal is to use a spi periperal on my custom board.
In this application we need to have 2 bytes transfert. That...
I can communicate with success from the pc to my custom nrf52832 device (SDK 15.2, S132v6.1) using the pc-ble-driver (sd_api_v3) with Tag 4.0.0 from Github. Great work!
...
