Dir Sir. I am checking the current profile of nRF24AP2 in RX mode.
After "open channel" command, I found the peak current at 10ms interval until connection pass.
How does...
Hello,
I am using Nordic's UART service to communicate with my project. I use iOS and also Master Control Panel (with a dongle) on a laptop.
I have two questions:
...
SWI*_IRQ is using by softdevice to send event to application, I want to know which priority does softdevice set for them?
Does sd_nvic_critical_region_enter() disable...
I am a started guy.
I only need a bluetooth device (BLE) to check the signal and mac address.
What is the best choice?
I need the smallest and low powered!
Thank you...
I am working on code to setup a bond manager for ancs based off of the example, but have a fixed advertising and connection interval of 25ms. How does the bond manager and...
Hello,
We have experienced odd problem, we are not able to scroll up or down SDK documentation at these pages on Android devices. IPHONE browser Safari works ok. Any help...
Hi. I am trying to stop advertising after a delay in the UART example using;
sd_ble_gap_adv_stop(???)
What do I put in the brackets? It is asking for a uint8_t called...
Hi,
How to stop freeRTOS xtask using timer and recreate again when needed? I'm currently want to control the blink interval, for example I want to have the led blink for...
I used sdk15.2.
The peripheral sends the public key to the central.I received an exception to public key processing.
code:
case BLE_BITBUTTON_C_EVT_BITBOTTON_M_NOTIFICATION...
Hello Everyone,
Struggling with evaluation of Secure DFU over UART lines. I used the sample project "Secure DFU Bootloader over Serial Link (UART/USB) ", during the previous...
Hello -
Any advice on finding a connector from a standard NFC Antenna to the Molex 051281-0594 connector on the Nordic Thingy:52 Board?
I am trying to find a larger NFC...
Hi all,
As we see the release note of the Mesh SDK V3.0, one of the descriptions as below:
Example changes
Lowered the default Node Identity advertisement interval....
Dear support team,
i hope you are doing good.
i am using nrf51822 customized board, SDK 12.3.0 version keil 5.26 is development on windows environment.
softdevice...
We have an app that uses UART. It works flawlessly when only SD and app are present on a chip.
But if bootloader is used, UART does not work.
Why is it so? How to fix...
Hi,
I am using NRF52832 for my project. I need a support to handling oscillator
my project needs to reads the sensor raw data and through it in BLE_UART. and do calculation...
I am using nRF Connect for desktop v2.6.0 with an nRF51 dongle. On my device, my Bluetooth Device Name String is 23 characters long. The string is too long to completely show...
Hi,
I'm developing an android application with multiple BLE.
And I can connect more than one device and successfully disconnect what I want.
But I have one problem, when...
I am trying to analyze the BLE communication between my laptop ( Linux) and a BLE device. I have the BLE sniffer and the wireshark installed on the laptop. However, i am unable...
Hello Nordic team
I am working on nRF51822 MCU.
My question is I can generate the DFU zip file and it working with nRFConnect and nRF Tool Box mobile application. But...
