Hi,
Will PAN item #56 TWI: TWI module lock-up be fixed in the Rev 3 version of the nRF51822/51422?
Also would you happen to have a time frame as to when the Rev 3 will...
Close Bluetooth in Iphone's settings when IOS/51822 is paired and connected normally.
several seconds later, Open Bluetooth in the settings again, and observe the settings...
Hi,
I am trying to power off and/or disable a RR[0] with no success.
I am Powering OFF the watchdog in main and then successfully POWERing ON in wdt_init but then I...
Is it possible when using the S110 softdevice to limit the maximum number of packets per connection event? I would like to reduce the maximum amount of time the CPU spends...
I am using nRF51422 Evaluation Kit with the latest silicon revision which comes with programmable softdevice. The kit also contains an ANT USB-m dongle. I have followed the...
I tried to do send & receive binary data from bluetooth in ios app.
But i only can send & receive string or ASCII code data in my app, do you have any method or idea can...
Hi,
I tried ble_app_hids_mouse with Android 4.4.2, it can work properly for first time connection. However, it cannot be re-connected after switching Phone's Bluetooth...
On a custom board with an nRF52832 communicating over UART with another microcontroller with no flow control capability.
SDK 13.0.0-1.alpha with an S132SD.
I have some...
Hello everyone,
Thanks in advance for your patience in reading this long message.
I have been having problems with UART over USB on PCA10040 boards for almost four months...
In order to learn how to use the RTC0 to handle an event every second, I am debugging the rtc SDK example.
Expectation : The rtc example sets the time to check the counter...
I need to make sure that the receiver is active in an NRF52832 that I don't have good ability to do DTM commands on; there's a host processor that can do some DTM commands...
For me the sample can be compiled but does not work with PC. SDK is 13.1. OS is W10. Serial port is installed automatically by using W10 standard driver (usbser.inf). There...
I see that there is a white box around the nRF52 chip and I was wondering if it was boxing up the core components to make a functional nRF52832 breakout board?
Hi all,
It could be something simple, but I cant get it yet.
If I increase:
NRF_BLE_GATT_MAX_MTU_SIZE from 23 to 247 on sdk_config.h
attr_char_value.max_len inside...
Hello, I use BLE NUS since one year to service a device. I recently got to SDK13, using SD132.
When I use iOS9 everything is ok. But when I use iOS10, the tx characteristic...
Im on an nRF52832, using the BLE Mesh 0.9.1 alpha release
I've followed the DFU Quickstart guide, and have been able to DFU the app_green_s132.hex, which is the prebuilt...
hi,
i am using NRF52 custom board. i want to provide serial number to each board, which i want to read or write any time using my firmware. if i erase the bord it should...
Hi,
I have a BLE nano v1.5 from RedBear. I want to use s120 SoftDevice developed for the nRF51822 and for what i've read this is not available for programming with mbed...
