Hi,
Recently I want to set up a dynamic network that with the node change this position ,the network will change dynamically.But there is the question,with the node's position...
Dir Sir. I am checking the current profile of nRF24AP2 in RX mode.
After "open channel" command, I found the peak current at 10ms interval until connection pass.
How does...
Hello,
I am using Nordic's UART service to communicate with my project. I use iOS and also Master Control Panel (with a dongle) on a laptop.
I have two questions:
...
SWI*_IRQ is using by softdevice to send event to application, I want to know which priority does softdevice set for them?
Does sd_nvic_critical_region_enter() disable...
I am a started guy.
I only need a bluetooth device (BLE) to check the signal and mac address.
What is the best choice?
I need the smallest and low powered!
Thank you...
I am working on code to setup a bond manager for ancs based off of the example, but have a fixed advertising and connection interval of 25ms. How does the bond manager and...
I'm attempting to write to flash memory on our custom board using the nRF52840 using the NVS library in Zephyr 1.5.0. I've ported over the example code from samples/subsys...
Hi everyone,
I try to get manufacturer data with central device.
The peripheral device is normally correctly configured for both advertisement report and scan response...
Hello.
Actually I have two qustions, but they are related with the same challenge.
So, I want to develop application using SDK (libararies and config), but starting from...
Dear ,
Thanks a lot for your time.
We currently have a project using nRF52840 dongle and nRF connect SDK, implementing FATFS and USB MSC SD card examples together.
The...
Hello
When I use ncs1.7.1 52840 + mcuboot + spi + external flash it works well, but when I update ncs to 1.8.0 I can't build it.
I also add CONFIG_MULTITHREADING =y in...
I'm trying to get my nRF9160DK board to connect to nRF Cloud, but I ran into some issues and it's not working. I've followed every step of the nRF9160DK Getting Started Guide...
I have configured the ADC on my nRF52832 to trigger a read based on a PPI timer. I am using EasyDMA to capture 75 samples via double buffering. My PPI timer is configured...
I am migrating my project to C++. Everything in the SDK works so far except NRF_BLE_GATT_DEF(). This returns the error C++ requires a type specifier for all declarations....
I'm using FDS on SDK16.0.0 to store some value, consisting of 12 int32_t values. They are stored correctly, except the first byte. Here is my code used to store :
It prints...
Hello,
is there any way to connect additional sensors using SPI or I2C to the thingy:91?
From the schematics I see test points on the PCB that allow access to the SPI...
Hi, we have a costumer who wants be able to do a firmware update over BLE. We have a running application that takes about 260k of FLASH. This fits in the NRF52832 (512k FLASH...
Hi All,
i have implemented peripheral_cts_client example
but i want to read value once from nrf_connect_app(cts server) then cts has to maintain the time and update it...
Hello sir, I'm now working on the nrf52840 and am having trouble with the sdk config. Initially, I indicated that I was working with spim3 and that it was functioning OK;...
