Hi,
Recently I want to set up a dynamic network that with the node change this position ,the network will change dynamically.But there is the question,with the node's position...
Dir Sir. I am checking the current profile of nRF24AP2 in RX mode.
After "open channel" command, I found the peak current at 10ms interval until connection pass.
How does...
Hello,
I am using Nordic's UART service to communicate with my project. I use iOS and also Master Control Panel (with a dongle) on a laptop.
I have two questions:
...
SWI*_IRQ is using by softdevice to send event to application, I want to know which priority does softdevice set for them?
Does sd_nvic_critical_region_enter() disable...
I am a started guy.
I only need a bluetooth device (BLE) to check the signal and mac address.
What is the best choice?
I need the smallest and low powered!
Thank you...
I am working on code to setup a bond manager for ancs based off of the example, but have a fixed advertising and connection interval of 25ms. How does the bond manager and...
Hi there,
Attempting to use the sample program for direction finding and have been following Case ID: 280319. Have attempted to add the code suggested by Simonr in adding...
Hi,
I'm working on a project using Zephyr and ncs 1.7.1. One of its functions is to stream WAV files from a SD card. It only ever reads data.
The issue I'm having is...
Hi all,
I am using SES in Win10. After I updated my NCS to 1.7.1, I failed to open my solution. However, it runs succussfully in SDK 1.6.1. The infomation is below:
...
Hello.
I am currently working on implementing a PWM control function using nrf52840. I used the function "es_battery_voltage_get()" to read the battery voltage before and...
I have written simple hello world code on nRF9160 custom board and enables the MCUBoot as bootloader using CONFIG_BOOTLOADER_MCUBOOT=y in prj.conf file.
Also, made some...
Hi everyone, I'm trying to communicate with OBDII through NUS using nRF52832. I was able to initiate the connection, send commands to OBDII, and get responses on the ECUsim...
The current RRC Inactivity Timer from my provider is 10 seconds, causing my power consumption in RRC Connected mode to be unnecessarily high.
I want to use the Release Assistance...
Hi,
Can anyone check if my understanding about this NFC-BLE pairing feature is correct?
1.Before connecting, two BLE devices will exchange some keys or info for secure...
Hello,
I'm working on an application that will use the nrf9160/nrf52. I will need to make https REST calls where I will populate the http header with username/password credentials...
I didn't manage to find a solution to my problem here but I fixed it myself so I'm posting it just in case it helps someone else.
I installed JLink 5.12.6 and nRF5x Command...
Hi,
Android shows a message that the NFC Pairing was not successful, but it looks that the connection was established successfully (Device in the connected devices, data...
Hi All,
I have a measuring device that needs to send UART data over BLE to a PC with BLE dongle or Macbook with built in BLE. My test users need to open up a webpage in...
Okay, I've run into an interesting scenario.
SDK 17.0.2
NRF 52840 (DK)
I am coding a multiperipharal service on a multiperipheral ble device.
My attempt at updating...
Hello,
Does Nordic have a Google Flutter example mobile app for MCUBoot and MCUMgr based DFU (built with nRF Connect SDK) ?
If not, does someone on this forum know about...
