I am working on code to setup a bond manager for ancs based off of the example, but have a fixed advertising and connection interval of 25ms. How does the bond manager and...
Hello,
We have experienced odd problem, we are not able to scroll up or down SDK documentation at these pages on Android devices. IPHONE browser Safari works ok. Any help...
HI,ALL！
I tried to add a RTC wakeup funtion to my ble device, so i add the code of the Nordic board example named "rtc_example" to my program.
But it turned out that my...
Hi,
I'm working on a Keyboard&Touchpad project, very similar configuration with Smart Remote 2, so I'm considering to use nRF24LU1+ as receiver's MCU. The receiver will be...
uint32_t ble_advdata_set (const ble_advdata_t *p_advdata, const ble_advdata_t *p_srdata)
If I set the second parameter p_srdata, does it mean passing encoded advertising...
Hey everyone,
I basically have the same question as it was discussed in this ticket: How to get unicast address on mesh server. - Nordic Q&A - Nordic DevZone - Nordic DevZone...
Hello, I'm currently planning a product that involves Bluetooth technology and came across the NRF5340 chip. I see that I can get the development kit which is a board with...
Hi,
On nRF5340 development board I followed the instructions in this link and ran the blinky example successfully: Getting Started Guide — Zephyr Project Documentation...
I got an error here err_code = pm_init(); APP_ERROR_CHECK(err_code);
<error> nrf_ble_lesc: nrf_crypto_ecc_key_pair_generate() returned error 0x8502.
<error> peer_manager...
I am using the BLE sniffer in Wireshark (nrf 52840 dev kit board) to attempt to capture packets between a BLE device and android phone. I am able to sniff advertising packets...
Hi,
I have faced an issue with cmsis_v1 thread creation/removal with the SDK connect.
I have created the following ticket on zephyr's side and attached the patch I'm...
Hello,
How to find NRF connect mobile app server's address in the app to be used for connecting to peer devices ? Is there any way that the device address does not change...
Hi,
We are currently implementing the nRF52840 in an upcoming product and we have a question regarding component selection for our configuration.
I've looked through...
Hello
I really need your help !
I am using SEGGER Embedded studio with two EV boards: nRF9160 and NRF52 DK
First I started with NRF9160 with clean installation of the...
Hi
H have developed a program for nRF51822 using "Arduino IED" and "BLEPeripheral" library, that performs an operation.
The operation is a button press and on each press...
Hello,
My board reads data from acceleration sensor and sends it to ESB message.
When acceleration is under threshold, nRF52832 went sleep mode.
Before entering sleep...
Hi...
I am using Nordic SDK V17.0.2 with a SoftDevice S112 and developing a project uses freeRTOS that came with this SDK
From reading the documentation about the...
