Hi,
Recently I want to set up a dynamic network that with the node change this position ,the network will change dynamically.But there is the question,with the node's position...
Dir Sir. I am checking the current profile of nRF24AP2 in RX mode.
After "open channel" command, I found the peak current at 10ms interval until connection pass.
How does...
Hello,
I am using Nordic's UART service to communicate with my project. I use iOS and also Master Control Panel (with a dongle) on a laptop.
I have two questions:
...
SWI*_IRQ is using by softdevice to send event to application, I want to know which priority does softdevice set for them?
Does sd_nvic_critical_region_enter() disable...
I am a started guy.
I only need a bluetooth device (BLE) to check the signal and mac address.
What is the best choice?
I need the smallest and low powered!
Thank you...
I am working on code to setup a bond manager for ancs based off of the example, but have a fixed advertising and connection interval of 25ms. How does the bond manager and...
Hi,
I am developing the system where I am sending the data of three sensors to the server using MQTT. For the above development, I used two microcontrollers one to collect...
Hi Nordic Team,
I would like to share with you a minor challenge that we are facing to use the nRF52840 dongle with a Zigbee Mesh network and issuing a serial communication...
Hello,
Does anybody know where I'll be able to find an EAGLE library for the nRF52840 CKAA chip (the WLCSP-93 package)? I've looked around and all other dev boards that...
Hi,
I'm having doubts about whether to use NUS or OTS to transfer 500 bytes of data from the peripheral device to the smartphone. Regarding OTS, I've tried using the ble_ots_central...
Hello.
I am developing using nrf52832 (S132 v7.0.1, SDK v16.0.0) as a central and Android device (Bluetooth 4.2) as an advertisement.
During development, I was wondering...
Hello,
Following is my hardware and firmware setup.
Thread BR:
PCA10100 v1.0.0 connected over J-Link microUSB port to RPi 3B+
SDK v4.1.0
Thread Node:
PCA10100...
Hi,
If using a serialization connection to a BLE module. The application will run on the host MUC and the BLE module only runs the SoftDevice (BLE stack). I understand that...
I'm running the unmodified blinky example on the 52840 dongle PCA10059 and it connects just fine with the nrf connect app but will not pair with the phone via the Android...
Excuse me:
When I was testing the OTA of nrf52820 chip, there was a download error in the command line tool。Here are my steps in nrfjprog tool：
1、nrfutil settings generate...
Hi,
I am running the Mesh Light Switch Example Code on My custom board (nRF52840) by changing the BSP_ LED_0 from 13 to 33(LED pin no on my custom board) pin number,but...
Hi teams,
I am trying to implement Decawave DW3000 functions to nRF52833DK as host.
Decawave provides some APIs for nRF52840DK, and I have succeeded make it working on...
nd Since i am still a newbie to nordic i wanted to know how can i break the task in smaller steps.
1)As a first step i get the values in temperature form using saadc.
...
