Hi,
Recently I want to set up a dynamic network that with the node change this position ,the network will change dynamically.But there is the question,with the node's position...
Dir Sir. I am checking the current profile of nRF24AP2 in RX mode.
After "open channel" command, I found the peak current at 10ms interval until connection pass.
How does...
Hello,
I am using Nordic's UART service to communicate with my project. I use iOS and also Master Control Panel (with a dongle) on a laptop.
I have two questions:
...
SWI*_IRQ is using by softdevice to send event to application, I want to know which priority does softdevice set for them?
Does sd_nvic_critical_region_enter() disable...
I am a started guy.
I only need a bluetooth device (BLE) to check the signal and mac address.
What is the best choice?
I need the smallest and low powered!
Thank you...
I am working on code to setup a bond manager for ancs based off of the example, but have a fixed advertising and connection interval of 25ms. How does the bond manager and...
Hi everyone,
I am writting a custom firmware and I am stacked on how to manipulate properly BLE events. First of all I have a handler function that listens for BLE events...
Is the mesh 4.2.0 sdk documentation available for download? I know that the sdk16.0.0 was downloadable on the infocenter ? But the same is not available for mesh 4.2.0. Where...
Hi all,
Is there any difference between advertising in IDLE mode and stop advertising using sd_ble_gap_adv_stop(m_advertising.adv_handle)? I wonder if I need to stop the...
I'm using the script from https://devzone.nordicsemi.com/f/nordic-q-a/53208/updating-nrf9160-modem-firmware-through-the-command-line/215357#215357
Under strace, it never...
Hi,
I need to reset RAM after softreset. As I read product specification, RAM cannot be cleared after softreset or CPU lockup.
Please see below image for reference.
...
I've been experimenting with using mqtt discontinuously, and have run into an issue where it appears to leak memory, leading to a subsequent mqtt_connect failing with -12...
nRF52832 offers several different Bluetooth modes such as :
(1) Nordic Proprietary 1 Mbps
(2) Nordic Proprietary 2 Mbps
(3) Bluetooth LE 1 Mbps
(4) Bluetooth LE 2...
Hi,
The instruction from the ' Getting started with Nordic's Secure DFU bootloader, a step by step guide ' page tels us to use minGW and GCC compiler to perform a 'make...
Hi,
I am following this example here , which sends an https HEAD request to google.com as a starting point for my overall goal, which is to send an https GET or POST request...
Hi,
I am a interested in using a nRF52 development board as a BLE Mesh packet sniffer when paired with Wireshark. My question is which of the nRF52 boards support mesh....
Hello,
There are lots of old threads about using nRF51 and nRF52-DK with Wireshark and special Sniffer firmware. The newer nRF52840 Dongle, however, doesnt seem to have...
Hello,
I am developing an nrf52811 BLE Direction Finding firmware.
During packet reception I would like to store the IQ samples on a uint8_t buffer right after some...
I have enable 4 Low power events for 4 button in NRF52832 board. when i press a button board is waking up due to low power event
but when it is waiting in low power mode...
Hi,
I am using nrfUtil on my iPad to update my nrf52 devices through DFU. Since the nrfUtil last update, I can't figure out how to delete the old zip package file on my...
