Dir Sir. I am checking the current profile of nRF24AP2 in RX mode.
After "open channel" command, I found the peak current at 10ms interval until connection pass.
How does...
Hello,
I am using Nordic's UART service to communicate with my project. I use iOS and also Master Control Panel (with a dongle) on a laptop.
I have two questions:
...
SWI*_IRQ is using by softdevice to send event to application, I want to know which priority does softdevice set for them?
Does sd_nvic_critical_region_enter() disable...
I am a started guy.
I only need a bluetooth device (BLE) to check the signal and mac address.
What is the best choice?
I need the smallest and low powered!
Thank you...
I am working on code to setup a bond manager for ancs based off of the example, but have a fixed advertising and connection interval of 25ms. How does the bond manager and...
Hello,
We have experienced odd problem, we are not able to scroll up or down SDK documentation at these pages on Android devices. IPHONE browser Safari works ok. Any help...
Hi,
I am using nRF52840 Preview DK with SDK version 15.3
I want to connect to a peripheral and configure some of its behavior such as Transmission power, Transmission...
Hello! I am using nRF5 SDK 15.3.0. The SPIM sck and the QSPI sck pin is same on my Pcb. When i initialized both peripheral SPIM works well ,but the QSPI not works. Is there...
Hi
I'm currently struggling a bit with the zboss API. I am trying to define 2 lights on my nRF52840 DK board. Via Amazon Alexa, it should be possible to control these two...
Hello,
I'm starting design on a new BLE dongle project.
I am planning to use nRF52840 and an external flash memory for storing sensor data. I need to include timestamp...
Somewhat doubtfully updated to DAPLINK, followed the guide re - turning off services/storage service to get this update to work. All looked good.
but board now appears BRICKED...
Hello everyone,
I want to ask whether the NRF51822 can exit SYSTEM OFF mode with interrupt from a timer?
In the user guide I read:
The system can be woken up from...
Hi,
I have developed a application on nRF51822 that is detect eBeacon and read some information in Beacon and Scan reponse frames.
There is about 200 systems deployed...
Hi, I have been working with the nRF52840-DK and the dongle for some time with OpenThread and it works great. I have now built a mesh application which I want to run on the...
Dear Ladies and Gentlemen
We recently received two Bluetooth 5.0 modules, one nRF52840- and one nRF52832 developmentkit. The aim is to use these two bluetooth devices...
It looks like that 1Mb flash is useful for people like me who don't want to worry about external flash. The question I have is how aggressively I can use the storage? It only...
Hi
i have below requirement:
My device acts as central and i am using db discovery module to discover services which are registered using ble_db_discovery_evt_register...
Hi,
I am tryin to erase the DK board using nRFgo studio, but it not detecting the device.
It get detected in SES studio and programmed also. We reset the baord and...
Dear Nordic Team
Im developing my own BLE Adapter. I realised the Hardware using
NRF52810. SOC
Now im Testing some functions of the Print and so far a lot seams to work...
